摘要
本文利用ProE/5.0建立2/3捻距钢绳环非连续接触三维模型,在Abaqus中进行轴向拉伸和扭转载荷下的非连续接触钢绳环有限元分析,在非连续接触钢绳环损伤试验台上对钢丝绳进行磨损实验,并借助光学显微镜(OM)对磨损后钢丝表面磨痕分布进行了分析,结果表明:等效应力、轴向应力、轴向变形均沿钢丝绳轴线方向呈螺旋状分布,在绳股截面上,等效应力由芯丝向侧丝逐渐递增,在绳槽接触区域出现最大值,实验表明钢丝表面也呈现椭圆磨痕,与仿真结果相一致。
In this paper, the 3-D model of discontinuous contact of 2/3 lay length steel rope is established by ProE/5.0. Finite element analysis of discontinuous contact steel rope under axial tension and torsion load was carried out in ABAQUS. The wear test of wire rope was carried out on the discontinuous contact steel wire rope damage test bench, and the distribution of wear marks on the worn steel wire surface was analyzed by optical microscope(OM). The results show that the equivalent stress, axial stress and axial deformation are spiral distribution along the axial direction of the wire rope;on the strand section, the equivalent stress increases gradually from the core wire to the side wire, the maximum value appears in the contact area of rope groove, the experimental results show that the steel wire surface also presents elliptical wear scar, which is consistent with the simulation results.
作者
张武
吴景亮
刘怡杉
孙士山
贾艳平
ZHANG Wu;WU JingLiang;LIU YiShan;SUN ShiShan;JIA YanPing(School of Mechanical Engineering,Xi’an University of Science and Technology,Xi'an 110054,China)
出处
《机械强度》
CAS
CSCD
北大核心
2021年第6期1498-1503,共6页
Journal of Mechanical Strength
基金
西安市科技计划项目(2019217714GXRC013CG014-GXYD13.7)
陕西省重点研发计划项目一般项目(2018GY-163)
西安科技大学优秀青年科技基金(2019YQ2-12)资助。
关键词
非连续接触
钢丝绳
磨痕
应力与变形
Discontinuous contact
Wire rope
Wear scar
Stress and deformation
作者简介
张武,男,1985年8月生,陕西咸阳人,汉族。西安科技大学副教授,硕导,主要研究方向为乘用车无级变速传动设计与理论分析、混合动力汽车传动系统设计、机械系统做动磨损分析;通信作者:吴景亮,男,1992年7月生,河南周口人,汉族。西安科技大学在读硕士研究生、主要研究方向为钢绳环式无级变速器钢绳环非连续接触有限元分析及摩擦磨损相关研究。
