摘要
针对夹矸工况,研究EBZ160掘进机截割部运动参数对截割性能的影响。在三维实体建模软件构建掘进机截割头模型,合理简化巷道煤岩组成结构,在EDEM中建立夹矸煤壁模型,搭建截割头-煤壁的仿真实验,通过单因素实验法进行分组模拟,在MATLAB中绘制性能指标的变化曲线并进行分析。结论:EBZ160掘进机在夹矸工况下的截割部最佳运动参数配置为摆速:2~3 m/min,转速:40~50 r/min,进给量:600~650 mm。
The influence of motion parameters of cutting part of EBZ160 roadheader on cutting performance is studied.In the three-dimensional solid modeling software,the roadheader cutting head model is constructed,the coal and rock composition structure of the roadway is reasonably simplified,the coal wall model of the gangue is established in EDEM,and the simulation experiment of the cutting head-coal wall is built.The single factor experiment method is used to simulate the grouping,and the change curve of the performance index is drawn and analyzed in MATLAB.Conclusion:the best motion parameters of cutting part of EBZ160 roadheader under the condition of dirt band are swing speed:2-3 m/min,rotational speed:40-50 r/min,feed:600-650 mm.
作者
井庆贺
宋文杰
张启良
李哲
黄好君
王释豪
谢苗
蒋泽旭
吴霞
JING Qinghe;SONG Wenjie;ZHANG Qiliang;LI Zhe;HUANG Haojun;WANG Shihao;XIE Miao;JIANG Zexu;WU Xia(Jalai Nur Coal Mine Co.,Ltd.,Manzhouli 021400,China;Linglu Coal Mine,Jalai Nur Coal Mine Co.,Ltd.,Manzhouli 021400,China;Liaoning Technical University,Fuxin 123000,China)
出处
《煤炭技术》
CAS
北大核心
2023年第8期211-215,共5页
Coal Technology
基金
中国华能集团横向课题(HNKJ21-HF56-03)。
关键词
掘进机
截割性能
运动参数
EDEM仿真
roadheader
cutting performance
motion parameters
EDEM simulation
作者简介
井庆贺(1972-),内蒙古呼伦贝尔人,高级工程师,硕士,研究方向:机械设计及理论,电子信箱:380357369@qq.com.
