期刊文献+

热轧润滑对IF钢表面状态的影响 被引量:2

Effect of Hot Rolling Lubrication on Surface State of IF Steel
在线阅读 下载PDF
导出
摘要 利用热轧试验和实验室模拟研究了热轧润滑对IF钢全流程各工序后表面状态的影响。结果表明:关闭热轧润滑使得热轧卷表面存在较多的细小晶粒和混晶,增加辊面与带钢表层剪切应力是造成细小晶粒的根本原因;混晶组织对连退板组织有明显遗传性,导致冷轧,退火后的连退板表层{111}/{100}织构比例下降。 The effect of hot rolling lubrication on the surface state of IF steel after each process was studied by hot rolling test and laboratory simulation.The results show that there are many fine grains and mixed crystal on the surface of hot rolled strip due to the shut off the rolling lubrication,and the increase of shear stress between roll surface and strip surface is the basic cause of fine grains.The mixed crystal structure has obvious heredity,which leads to the decrease of{111}/{100}texture ratio on the surface of the continuous annealing plate after cold rolling and annealing.
作者 王畅 于洋 关建东 王林 高小丽 陈瑾 WANG Chang;YU Yang;GUAN Jiandong;WANG Lin;GAO Xiaoli;CHEN Jin(Research Institute of Technology of Shougang Group Co.,Ltd.,Beijing 100043,China;Beijing Shougang Co.,Ltd.,Beijing 100043,China;Beijing Key Laboratory of Green Recyclable Process for Iron&Steel Production Technology,Beijing 100043,China)
出处 《热加工工艺》 北大核心 2023年第9期95-97,102,共4页 Hot Working Technology
基金 2019年度山西省高等学校科技创新资助项目(2019L0995)。
关键词 IF钢 表面质量 轧制润滑 混晶 IF steel surface quality rolling lubrication mixed crystal
作者简介 王畅(1986-),女,辽宁葫芦岛人,高级工程师,硕士研究生,主要从事热轧及冷轧产品表面质量控制工作,E-mail:ustb0321033@126.com。
  • 相关文献

参考文献5

二级参考文献12

  • 1[1]Cobo S J,Sellars C M. Microstructural Evolution of Austenite under Conditions Simulating Thin Slab Casting and Hot Direct Rolling. Ironmaking and Steelmaking, 2001,28(30):230~236.
  • 2[5]Li,W; Wang,Y; Yan,MF.Wear rate,Frictional Temperature,and Energy Consumption of Steel 52100 With Different Microstructures During Sliding[J].Journal of Materials Science,2005,40(21):5635-5640.
  • 3[8]Gianpiero Benedetti.Design Concepts Forthe Next Minimill Generation[J].Iron and Steel Review,2004,47(8):578-766.
  • 4[9]Alleva L; Bufalini A; Brascugli G; Direct Annealing-A New Route in the Production Cycle of 430 Ferriticstainless Steel[J].ThyssenKrupp Techforum,2004,(6):18-23.
  • 5[1]JFE R&D Corporation.Preventing Global Warming at JFE Steel[R].Japan:JFE Environmental Report,2004,20-22.
  • 6[2]C.Reip W.Hennig; J.Kempken.Development of CSP Processed High Strength Pipe Steels[J].Materials Science Forum,2005,500(3):287-294.
  • 7[4]Anil Vaswani.Effective Waste Heat Recovery With Twinbed Regenerative Burners[J].Iron and Steel Review,2003,46 (8):30-33.
  • 8张树堂.连铸坯热送热装类型及相关的冶金学问题[J].轧钢,1998,15(5):3-6. 被引量:32
  • 9张务林.特殊钢轧钢节能的措施和方向[J].特钢技术,1998,5(3):9-16. 被引量:3
  • 10杭乃勤,沈巧珍,黄宁,王申林,杨大可,段家田.棒线材连轧过程能耗优化设计[J].钢铁,2000,35(1):23-27. 被引量:2

共引文献32

同被引文献24

引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部