摘要
对2219-T6铝合金激光同轴辅助搅拌摩擦焊接头的宏观形貌、力学性能及显微组织进行了研究.结果表明,激光辅助热源的加入有助于消除金属塑性流动不充分引起的隧道缺陷,提升接头性能,但激光功率过大会加剧焊缝软化而使性能下降.激光辅助热源使焊核区扩大,且焊核区中θ相(Al2Cu)增大,但对热力影响区的显微组织无明显影响.通过固溶+人工时效方法的焊后热处理以显著提升接头强度(从母材强度的76%提升100%).加入激光的焊核区及热力影响区在热处理后晶粒尺寸相比不加入激光有所减小,且激光功率越大,对应的晶粒尺寸越小.
Laser coaxially assisted friction stir welding process of 2219-T6 aluminum alloy was investigated,concentrating on weld appearance,mechanical properties and microstructure characteristics of the joints.The results show that assisted laser heat can effectively prevent tunnel defect,thus improving joint performance.However,high laser power increases softening of the welded zone and decreases joint performance.Assisted laser heat enlarges the nugget zone(NZ)and increases the size of 0 phase(AI2Cu),but has no obvious effect on microstructures of thermo-mechanically affected zone(TMAZ).T6 heat treatment of the welded joints can obviously increase the joint strength(from 76%of base metal to 100%).The grain sizes in NZ and TMAZ of joints with assisted laser heat are smaller than those without assisted laser after heat treatment.
作者
张婧
封小松
许辉
高嘉爽
ZHANG Jing;FENG Xiaosong;XU Hui;GAO Jiashuang(Shanghai Aerospace Equipments Manufacturer,Shanghai 200245,China)
出处
《焊接学报》
EI
CAS
CSCD
北大核心
2018年第8期82-86,133,共6页
Transactions of The China Welding Institution
关键词
激光同轴辅助搅拌摩擦焊
力学性能
显微组织
焊后热处理
laser assisted friction stir welding
mech anical properties
microstructure
heat treatment
作者简介
张婧,女,1982年出生,博士,工程师,主要从事焊接工艺方面的科研工作,发表论文20余篇,Email:destemymuyu@163,com。
