摘要
研究了钛表面氧化对钛/瓷结合强度的影响,并采用溶胶-凝胶技术在钛表面制备SnOx中间层,研究SnOx层对钛/瓷结合强度的影响.结果表明:空气炉中800℃氧化3min后,钛/瓷结合强度明显下降;烤瓷炉中预氧化3min,钛/瓷结合强度无明显变化.热处理使钛表面生成一层金红石型氧化层,钛/瓷剥脱主要发生在金红石氧化层与钛之间.采用溶胶-凝胶法经300℃处理后在钛表面制得的SnOx涂层,可有效隔绝氧向Ti表面的扩散,防止钛表面的过度氧化,提高了钛/瓷结合强度.经SnOx涂层处理后,钛/瓷剥脱主要发生在SnOx涂层内.
Effects of titanium surface oxidation on titanium-ceramic adhesion were investigated. Cast pure titanium was subjected to pre-oxidation and introduction of an intermediate layer of SnOx by sol-gel process. Specimen surfaces were characterized by XRD and SEM/EDS. The adhesion between the titanium and porcelain was evaluated by three-point flexure bond test. A rutile layer is formed on the titanium surface after pre-oxidation. Failure of the titanium-porcelain with pre-oxidation treatment predominantly occurs at the titanium-oxide interface. Pre-oxidation treatment does not affect the fracture mode of the titanium-porcelain system. The rutile layer is more strongly bonded to the porcelain than titanium. The poor adhesion of the rutile with substrate is due to the thermal stress arising from the large lattice mismatch and difference in coefficient of thermal expansion between Ti and rutile during cooling. However, a thin and coherent SnOx film with small spherical pores obtained after heat-treated at 300℃ serves as an effective oxygen diffusion barrier to improve titanium-ceramic adhesion. The SnOx films change the fracture mode of the titanium-porcelain system and improve the mechanical and chemical bonding between porcelain and titanium, resulting in the increased bonding strength of titanium-porcelain.
出处
《无机材料学报》
SCIE
EI
CAS
CSCD
北大核心
2009年第5期915-918,共4页
Journal of Inorganic Materials
关键词
氧化
钛/瓷结合
三点弯曲法
牙科材料
oxidation titanium-porcelain bonding three-point flexure bond test dental material
作者简介
郭立童（1981-），男，博士研究生．E-mail：guolitong810104@163．com
