摘要
This paper aims to study the effects of short basalt fiber reinforcement on the mechanical properties of cast aluminium alloy 7075 composites containing short basalt fiber of content ranging from 2.5 to 10 percent by weight in steps of 2.5 percent and fabricated using compo-casting technique. The objective is to investigate the process feasibility and resulting material properties such as young’s modulus, ductility, hardness & compression strength. The properties obtained are compared with those of as-cast that were manufactured under the same fabrication conditions. The results of this study revealed that, as the short basalt fiber content was increased, there were significant increases in the ultimate tensile strength, hardness, compressive strength and Young’s modulus, accompanied by a reduction in its ductility. Furthermore, the microstructure & facture studies were carried out using Optical Microscopy (OM) and Scanning Electron Microscopy (SEM) in order to establish relationships between the quality of the fiber/aluminium interface bond and hence to link with mechanical properties of the composites.
This paper aims to study the effects of short basalt fiber reinforcement on the mechanical properties of cast aluminium alloy 7075 composites containing short basalt fiber of content ranging from 2.5 to 10 percent by weight in steps of 2.5 percent and fabricated using compo-casting technique. The objective is to investigate the process feasibility and resulting material properties such as young’s modulus, ductility, hardness & compression strength. The properties obtained are compared with those of as-cast that were manufactured under the same fabrication conditions. The results of this study revealed that, as the short basalt fiber content was increased, there were significant increases in the ultimate tensile strength, hardness, compressive strength and Young’s modulus, accompanied by a reduction in its ductility. Furthermore, the microstructure & facture studies were carried out using Optical Microscopy (OM) and Scanning Electron Microscopy (SEM) in order to establish relationships between the quality of the fiber/aluminium interface bond and hence to link with mechanical properties of the composites.
