期刊文献+

高流速铅铋环境下板型燃料组件流致振动特性研究

Research on Flow Induced Vibration Characteristics of Plate Fuel Assembly in High-Flow Lead-bismuth Environment
原文传递
导出
摘要 液态铅铋合金具有导热性能好、热容量高等特点,是新一代先进反应堆的理想冷却剂。本文建立了高流速铅铋环境下板型燃料组件全尺寸计算流体动力学(CFD)模型,基于大涡模拟湍流模型开展了瞬态流体力学分析并获得了燃料板所受的流体激励力。建立燃料板CFD模型,基于瞬态流体激励数据开展基于时域的结构动力学计算并获得燃料板的位移响应。计算结果显示,由于吊装结构形成的漩涡脱落,中间位置燃料板所受流体激励力远大于两侧位置燃料板。燃料板位移响应集中于自身的一阶频率,并且单组燃料板的一阶频率远大于湍流激励主频,因此燃料板没有在流体激励下共振的风险。考虑到入口湍流强度影响,基于矩形流道功率密度谱的流致振动分析方法保守性能不足。本研究可为新一代高性能燃料组件研发提供参考。 Liquid lead-bismuth alloy has the characteristics of good thermal conductivity and high heat capacity,making it an ideal coolant for the new generation of advanced reactor.In this article,a full-scale computational fluid dynamics(CFD)model for plate fuel assembly in high-flow lead-bismuth environment was established,the transient fluid dynamics analysis based on large eddy simulation(LES)turbulence model was carried out and the fluid excitation force on the fuel plate was obtained.The dynamic analysis model of fuel plate was established,the structural dynamics calculation based on time domain was carried out according to the transient fluid excitation data,and the displacement response of fuel plate was obtained.The calculation results show that the fluid excitation force on the fuel plate in the middle position is much greater than that on the two sides because of the vortex shedding formed by the hoisting structure.The displacement response of the fuel plate concentrates on its own first-order frequency,and the first-order frequency of single fuel plate is much greater than the main frequency of turbulent excitation,so there is no risk of resonance of the fuel plate under fluid excitation.Considering the influence of inlet turbulence intensity,the conservatism of the flow induced vibration analysis method based on rectangular channel power density spectrum may be insufficient.This research can provide a reference for the development of new generation high-performance fuel assemblies.
作者 孙瑜 刘建 王浩煜 钱升 齐欢欢 Sun Yu;Liu Jian;Wang Haoyu;Qian Sheng;Qi Huanhuan(Science and Technology on Reactor System Design Technology Laboratory,Nuclear Power Institute of China,Chengdu,610213,China)
出处 《核动力工程》 EI CAS CSCD 北大核心 2024年第3期246-251,共6页 Nuclear Power Engineering
基金 中国核动力研究设计院核反应堆系统设计技术重点实验室基金课题(2022-JCJQ-LB-003)。
关键词 大涡模拟 流致振动 液态铅铋合金 Large eddy simulation Flow induced vibration Liquid lead-bismuth alloy
作者简介 孙瑜(1995-),男,硕士研究生,现主要从事核工程相关流致振动分析研究,E-mail:sunyu19950528@126.com。
  • 相关文献

参考文献3

二级参考文献14

  • 1薄涵亮 迟宗波 李德重 等.200MW低温核供热堆水力驱动控制棒系统综合性能实验与寿命考验[R].北京:清华大学核能技术设计研究院,1998..
  • 2Davis D C, Scarton H A. Flow-induced plastic collapse of stacked fuel plates [J]. Nuel Eng and Design, 1985, 85:193 - 200.
  • 3戴诗亮.随机振动实验技术[M].北京:清华大学出版社,1984..
  • 4薄涵亮.200 MW低温核供热堆水力驱动控制棒系统综合性能实验与寿命考验[R].北京:清华大学核能技术设计研究院,1998.2-8.
  • 5Jae Hyun Cho, Batta A. Benchmarking of thermal hydraulic loop models for Lead-Alloy Cooled Advanced Nuclear Energy System(LACANES), phase-I: Isothermal steady state forced convection [J]. Journal of Nuclear Materials, 2011,415: 404-414.
  • 6Borgohain A, Jaiswal B K, N K. Natural circulation studies in a lead bismuth eutectic loop [J]. Progress in Nuclear Energy, 2011, 52:308-319.
  • 7Ambrosini W, Forasassi G, Forgione N, et al. Experimental study on combined natural and gas- iniection enhanced circulation [J]. Nuclear Engineering and Design, 2005, 235:1179-1188.
  • 8Narain Armbya. CFD analysis of 3-d thermalhydraulius flow effects on wall concentration gradient proflies for leb loop fit-tongs [D]. University of Nevada, Las Vegas, 2004.7-8.
  • 9Borgohain A, Jaiswal B K, Maheshwari N K. Natural circulation studies in a lead bismuth eutectic loop [J]. Progress in Nuclear Energ, 201 1, 53, 308-319.
  • 10Bricteux L, Duponcheel M, Winckelmansa G. Direct and large eddy simulation of turbulent heat transfer at very low Prandtl number: application to lead-bismuth flows [J]. Nuclear Engineering and Design, 2012, 246: 91-97.

共引文献9

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部