摘要
为解决转辙机故障诊断领域中存在的单一特征信息提取不足、单一诊断方法难以避免因方法局限性造成的分类误差,同时其存在一定程度的过拟合,以及泛化能力、鲁棒性不足的问题,提出了一种基于时空特征组合模型的故障诊断方法。首先,在ZYJ7电液转辙机的8种故障模式和正常模式所对应的油压曲线上提取时频域小波系数作为原始数据集,采用核主成分分析(kernel principal component analysis,KPCA)和长短期记忆网络(long short-term memory network,LSTM)提取其空间、时间特征,之后基于ADD(addition)思想构建时空特征集。其次,对卷积神经网络(convolutional neural network,CNN)、LSTM两分类器关键参数寻优后分别进行故障诊断,得到各个故障类型的概率值和误差系数。最后,利用误差倒数法对两分类器各个故障类型的概率值赋予权重,得到最终输出结果。仿真结果表明:CNN-LSTM组合模型诊断准确率达98.14%,较单一多层感知机(multi-layer perceptron,MLP)、CNN、LSTM模型准确率分别提升7.40%、5.55%、1.85%。可见此方法有效提高了转辙机诊断准确率,为集成学习模型在转辙机故障诊断领域的应用提供了一种思路。
In order to solve the problem that the single feature information extraction is insufficient in the field of switch machine fault diagnosis,and the single diagnosis method is difficult to avoid the classification error caused by the limitation of the method.At the same time,it has a certain degree of over-fitting,as well as insufficient generalization ability and robustness.A fault diagnosis method based on spatiotemporal feature combination model was proposed.Firstly,the time-frequency domain wavelet coefficients were extracted from the oil pressure curves corresponding to the eight fault modes and normal modes of the ZYJ7 electro-hydraulic switch machine as the original data set.The kernel principal component analysis(KPCA)and long short-term memory network(LSTM)were used to extract the spatial and temporal features,and then the spatiotemporal feature set was constructed based on the addition(ADD)idea.Secondly,after optimizing the key parameters of convolutional neural network(CNN)and LSTM,the fault diagnosis was carried out respectively,and the probability value and error coefficient of each fault type were obtained.Finally,the error reciprocal method was used to assign weights to the probability values of each fault type of the two classifiers,and the final output result was obtained.The simulation results show that the diagnostic accuracy of CNN-LSTM combined model is 98.14%,which is 7.40%,5.55%and 1.85%higher than that of single multi-layer perceptron(MLP),CNN and LSTM models,respectively.It can be seen that this method effectively improves the accuracy of switch machine diagnosis,and provides an idea for the application of ensemble learning model in the field of switch machine fault diagnosis.
作者
刘琦
李建国
LIU Qi;LI Jian-guo(School of Automation and Electrical Engineering,Lanzhou Jiaotong University,Lanzhou 730070,China;Sidian BIM Engineering and Intelligent Application Railway Industry Key Laboratory,Lanzhou 730070,China)
出处
《科学技术与工程》
北大核心
2024年第13期5538-5545,共8页
Science Technology and Engineering
基金
教育部产学合作协同育人项目(202101023013)
甘肃省自然科学基金(20JR5RA396)。
关键词
故障诊断
组合模型
ZYJ7电液转辙机
深度学习
集成学习
fault diagnosis
combined model
ZYJ7 electro-hydraulic switch machine
deep learning
ensemble-learning
作者简介
第一作者:刘琦(1999-),男,汉族,山西大同人,硕士研究生。研究方向:交通信息工程及控制。E-mail:liuqi15536870386@163.com;通信作者:李建国(1974-),男,汉族,甘肃平凉人,博士,副教授。研究方向:交通信息工程及控制。E-mail:lijianguo@mail.lzjtu.cn。
