期刊文献+

巴西铁矿粉流态化还原条件优化研究 被引量:3

Study on the Optimization of Fluidization Reduction Conditions of Brazilian Iron Ore Powder
原文传递
导出
摘要 采用加压可视流化床装置,对巴西铁矿粉流态化还原行为进行研究,发现适当地增加压力可以提高金属化率,添加碳粉可以改善流化状态。为进一步优化还原时间、还原压力、还原气体线速度、还原温度、碳粉含量和碳粉粒径等因素对巴西铁矿粉还原的影响,采用六因素三水平正交试验方法,对还原后巴西铁矿粉样品进行金属化率和粘结比检测,发现不同还原条件对巴西铁矿粉的影响规律。研究发现纯氢气流态化还原巴西铁矿粉的最佳条件为:还原温度为923~1 023 K,还原气体线速度0.6 m/s,还原时间30~50 min,还原压力0.25 MPa,碳粉质量分数2%~6%(占矿粉质量),碳粉粒径4~7μm。 The reduction behavior of Brazilian iron ore powder was studied in a pressurized visible fluidized bed.It was found out that the metallization rate was increased by increasing the pressure properly,and the fluidization state improved by adding carbon powder.In order to further optimize the effects of reduction time,reduction pressure,linear velocity of reduction gas,reduction temperature,carbon content and particle size on the reduction of Brazilian mineral powder,six factors and three levels orthogonal experiment method were used to test the bond ratio and metallization rate of Brazilian mineral powder samples after reduction.Experiments resultsindicated that different reduction conditions had different effects on the reduction of Brazilian mineral powder.Optimum reduction temperature of Brazilian ore powder by pure hydrogen was 923~1 023 K,the linear velocity of reduction gas was 0.6 m/s,the reduction time was 30~50 min,the reduction pressure was 0.25 MPa,the content of carbon powder was 2%~6%(accounting for the quality of ore powder) and the particle size of carbon powder was 4~7 μm.
作者 徐其言 李志平 谷张涵 殷志宏 Xu Qiyan;Li Zhiping;Gu Zhanghan;Yin Zhihong(School of Metallurgy,Anhui University of Technology,Ma’anshan 243002,Anhui,China)
出处 《钢铁钒钛》 CAS 北大核心 2020年第3期99-104,共6页 Iron Steel Vanadium Titanium
基金 国家自然科学基金青年基金(No.51704003) 国家自然科学基金面上项目(No.51974001) 安徽省高校优秀青年人才项目(NO.gxyq2019016)。
关键词 巴西铁矿粉 流态化还原 压力 正交试验 Brazilian mineral powder fluidized reduction pressure orthogonal experiment
作者简介 徐其言(1982—),男,江苏睢宁人,博士,主要研究方向为直接还原与熔融还原。E-mail:qiyan.xu@ahut.edu.cn。
  • 相关文献

参考文献8

二级参考文献42

  • 1周继良,邹宗树,周渝生,余艾冰.流化床还原铁精矿粉动力学初算[J].过程工程学报,2008,8(S1):119-122. 被引量:2
  • 2石琳,程素森,孙天亮.高炉炉缸三维侵蚀形状的可视化技术[J].冶金自动化,2005,29(1):5-9. 被引量:4
  • 3刘云彩.高炉强化研究[A]..2003中国钢铁年会论文集[C].北京:冶金工业出版社,2003.392-394.
  • 4储满生,郭宪臻,沈峰满,八木顺一郎.多流体高炉数学模型的开发和应用[J].钢铁,2007,42(12):11-15. 被引量:12
  • 5Komatina M,Gudenau H W. The sticking problem during direct re-duction of fine iron ore in the fluidized bed[ J] . Metallurgical ,2004,10(4);309-328.
  • 6Edstrom J 0,Von Scheele J. Sponge iron and iron carbide;competi-tive raw materials for high-quality steelmaking [ J ]. ScandinavianJournal of Metallurgy,1997,26(5) : 196-205.
  • 7Dancy T E. The development of direct reduction processes[ J] . ScandJ Metallic, 1993,22:100-108.
  • 8李兆丰,王建军,罗林根,等.影响宝钢ORD-S矿粉还原因素研究[J].中国稀土学报,2010,28:628-633.
  • 9Reed III T M,Fenske M R. Effects of agitation on gas fluidization ofsolids[ J] . Industrial & Engineering Chemistry,1955,47 (2) :275-282.
  • 10Gransden J F, Sheasby J S. The sticking of iron ore during reductionby hydrogen in a fluidized bed[ J] . Canadian Metallurgical Quarter-ly,1974,13(4) :649-657.

共引文献102

同被引文献23

引证文献3

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部