摘要
为研究单点渐进成形铝合金零件壁厚均匀性的变化规律,采用数值模拟与实验相结合方法对2024铝合金正八边形锥件单点渐进成形过程进行了分析。通过建立单点渐进成形过程动力显式有限元模型,得到影响单点渐进成形板料厚度的因素。其中工具头直径的影响最大、进给量的次之,下压量的最小。采用实验方法对模拟结果进行验证,实验与数字模拟分析最大误差为7. 0%。
In order to improve the uniformity of wall thickness of aluminum alloy parts by single-point progressive forming,the single-point progressive forming process of 2024 aluminum alloy regular octagonal cone parts was analyzed by numerical simulation and experiment. By establishing the dynamic explicit finite element model of the single-point progressive forming process,the factors affecting the uniformity of single-point progressive forming wall thickness are obtained as follows: tool head diameter is the most influential one,feed amount is next to it,and down-pressure is the least influential;The simulation results were verified by experimental methods,and the maximum error between the test and digital simulation analysis was 7. 0%.
作者
何正琛
门正兴
刘志学
李红梅
周树强
HE Zheng-chen;MEN Zheng-xing;LIU Zhi-xue;LI Hong-mei;ZHOU Shu-qiang(Mechanical and Electrical Engineering Department,Chengdu Aeronautic Polytechnic,Chengdu 610021,China;School of Mechanotronics&Vehicle Engineering,Chongqing Jiaotong University,Chongqing 400074,China)
出处
《轻合金加工技术》
CAS
北大核心
2019年第11期57-60,67,共5页
Light Alloy Fabrication Technology
关键词
单点渐进成形
正八边形锥件
仿真模拟
减薄率
single-point progressive forming
regular octagonal cone part
simulation
thinning ratio
作者简介
第一作者:何正琛(1970-),男,四川南部人,副教授。
