摘要
在4辊轧机上轧制钛粉,通过调整工艺参数分析钛粉轧制的工艺过程。结果表明:轧制成品厚度与轧辊直径、喂料高度成正比;轧制速度越大,成品带厚度越小;辊缝越小,成品带厚度越小,但生坯带厚度减小值要小于辊缝的减小值。
Titanium powder was rolled on a 4-high rolling mill,and the rolling process was analyzed by adjusting process parameters. The results show that the thickness of rolled products is directly proportional to roll diameter and feeding height. The greater the rolling speed,the smaller the thickness of the rolled strip. The smaller the roll gap,the smaller the thickness of the rolled strip,but the reduction value of the green strip thickness is smaller than that of the roll gap.
作者
左碧强
丁文红
贺文健
毋刚
ZUO Bi-qiang;DING Wen-hong;HE Wen-jian;WU Gang(WISDRI Engineering & Research Incorporation Limited, Wuhan 430223, China;School of Materials and Metallurgy, University of Science and Technology Wuhan, Wuhan 430081, China)
出处
《粉末冶金工业》
CAS
北大核心
2019年第3期13-16,共4页
Powder Metallurgy Industry
关键词
钛粉
粉末轧制
轧制参数
titanium powder
powder rolling
rolling parameter
作者简介
左碧强(1984-),男,硕士,工程师,主要从事冷轧带钢、有色金属轧制的研究。
