摘要
两条金属轨道间的滑块在大电流的驱动下可获得高速,滑块与轨道接触界面的热特性影响接触状况和系统性能。本文利用电加热装置对轨道进行预加热,通过预加热来模拟电机连续推进下的热量累积。在滑块型号、质量、驱动电流基本一致的前提下,进行不同初始温度条件下的电机单次启动试验。通过温度、驱动电流、电压、运动速度等数据对大电流直线电机的性能进行分析,研究结果对于连续运行试验和避免转捩研究具有一定理论指导意义和工程应用参考价值。
The slider between two metal rails can get high speed under the drive of large current,and the thermal characteristics of the contact interface between the slider and the rails can affect the contact condition and the system performance.In this paper,the electric heating device is used to heat the rails,simulating the continuous heat accumulation of the motor by preheating.In the case that the slider type,mass,and driving current are basically consistent,the single starting test of motor is carried out with different initial temperature conditions.The performance of high current linear motor is analyzed by the data of temperature,driving current,voltage and motion speed and so on,laying a theoretical foundation and data support for continuous running test and avoiding transition.
作者
康凯
徐伟东
徐蓉
袁伟群
严萍
KANG Kai;XU Wei-dong;XU Rong;YUAN Wei-qun;YAN Ping(Institute of Electrical Engineering,Chinese Academy of Sciences,Beijng 100190,China;University of Chinese Academy of Sciences,Beijng 100049,China;Key Laboratory of Power Electronics and Electric Drive,Chinese Academy of Sciences,Beijing 100190,China)
出处
《电工电能新技术》
CSCD
北大核心
2018年第11期69-75,共7页
Advanced Technology of Electrical Engineering and Energy
基金
国家自然科学基金重点项目(51237007)
国家自然科学基金面上项目(51577178)
关键词
脉冲大电流
预加热
直线电机
滑块
pulse high current
preheating
linear motor
slider
作者简介
康凯(1990-),男,黑龙江籍,硕士研究生,研究方向为高电压与绝缘技术;袁伟群(1976-),男,江苏籍,研究员,博士,研究方向为脉冲功率技术(通讯作者)。
