摘要
在非圆齿轮的制造中,滚齿因难以加工节曲线内凹的非圆齿轮而导致对其使用较少,故对滚切加工非圆齿轮的研究也较少。但随着对制造业高效、环保、低能的要求逐渐提高,滚切加工非圆齿轮的重要性也日益凸显。简述了现有的非圆齿轮数控加工方法,着重阐述了非圆齿轮数控滚切的系统、加工工艺和加工误差三方面的研究现状。根据数控滚切非圆齿轮的研究现状提出展望。
In the manufacture of non-circular gears,the hobbing is less used because it is difficult to process the concave curve of non-circular gears,so there is little research on the non-circular gears.However,with the increasing demand for manufacturing,including the high efficiency,environmental protection and low energy consumption,the importance of rolling non-circular gear is also increasingly prominent.This paper briefly introduces the current NC machining methods of non-circular gears,and expounds the research status on NC rolling system,processing technology and machining error of non-circular gear.According to the research status of numerical control roll non-circular gear,the prospect is put forward.
作者
李先平
舒启林
李欢欢
LI Xianping;SHU Qilin;LI Huanhuan(School of Mechanical Engineering,Shenyang Ligong University,Shenyang 110159,China)
出处
《机械工程师》
2018年第2期9-12,共4页
Mechanical Engineer
基金
辽宁省科技攻关项目(2010219003)
关键词
非圆齿轮
插补
工艺优化
数控系统
non-circular gear
interpolation
process optimization
numerical control system
作者简介
李先平(1989—),男,硕士研究生,研究方向为先进数控技术;舒启林(1969—),男,博士,教授,研究方向为先进数控技术,现代设计理论与方法,产品数字化样机技术以及制造业信息化技术。通信作者:舒启林,lxpsmart@sina.com。
