期刊文献+

压单芯电缆单点接地方式的探讨

Research of Single Point Grounding of Single Core Cable
在线阅读 下载PDF
导出
摘要 高压单芯电缆在工程实践中,往往因为客观条件的限制,需采用金属护层单点接地方式。因此,需对电缆金属护层正常运行及接地短路时的护层感应电压进行分析计算,并针对云南特殊的环境要求,提出相应的处理意见和建议。 Because of the limits of the objective conditions, the high voltage single cable is always applied to the single point grounding mode. So, we need to promote the induced voltage analytical calculation of the metal jacket on power cables in cases of normal operation and grounded short circuit operation, and we promote the relevant opinions and suggestions aim at the special environmental requirements of Yunnan Province.
作者 杨坤池
出处 《云南电力技术》 2016年第3期63-64,共2页 Yunnan Electric Power
关键词 电缆金属护层 一点接地 接地短路 metal jacket on power cable one point grounding grounded short circuit
作者简介 杨坤池(1976),男,高级工程师,云南电网规划研究中心,从事规划评审工作(e-mail)237076510@qq.com。
  • 相关文献

参考文献3

  • 1GB50217-2007电力工程电缆设计规范[S].
  • 2DL/T5221-2005.城市电力电缆线路设计技术规定[S].[S].,..
  • 3李国争.电力电缆线路设计施工手册[M].中国电力出版社.2007.

共引文献151

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部