摘要
在热成形模具的设计中,模具冷却系统的水槽及入水口结构设计对冷却管道内水流速度的影响较大。利用Abaqus软件对淬火时冷却管道内的水流速度进行了数值模拟。结果表明:水槽内的储水量过大或过小都会降低冷却通道内水流速度;入水口直径大小对冷却通道内水流速度的影响最大。该研究结果对复杂热成形模具冷却系统的结构设计有一定的实际指导意义。
In the design of hot stamping die, water-flow velocity in the cooling pipeline is greatly in- fluenced by the structure of water tank and water inlet. This paper, with the assistance of software Abaqus, analyzed the process of numerical simulation of water-flow velocity in the cooling pipeline during quenching and drew several conclusions as follows： the oversized or undersized storage capacity of water tank will slow down the water-flow velocity in the cooling pipeline ; the most significant impact on the water-flow velocity in the cooling pipeline is the diameter of water inlet. Above all, the experi- mental conclusions will implement practical guidance to the structure design of the cooling systems of sophisticated hot stamping die.
出处
《重庆理工大学学报（自然科学）》
CAS
2014年第6期63-67,共5页
Journal of Chongqing University of Technology：Natural Science
基金
重庆市应用开发计划项目(cstc2013yykfA70001)
关键词
热成形
冷却管道
水流速度
hot stamping
cooling pipeline
water-flow velocity
作者简介
李小平（1968－），男，四川攀枝花人，副教授，高级工程师，主要从事板料成形工艺及模具技术研究。
