摘要
提出一种基于摄像机标定的非接触式接触线几何参数检测方法:在Matlab软件平台基础上,对CCD摄像机采集到的接触线二维图像进行预处理;利用迭代阈值法,对图像中由车载激光器发射到接触线上所形成的激光光斑的中心点进行定位;最后,根据摄像机针孔成像模型,将该激光光斑点在图像坐标系中的坐标与该点由摄像机标定的世界坐标系中的三维空间坐标建立对应关系,并据其算出接触线的几何参数。将用此方法计算与用光学测量仪对同一段实际线路测量的结果进行比较得知,此方法求得的拉出值与光学测量仪的实测值之差小于11mm,所得导高之差小于10mm。该结果表明:此方法较准确地计算出接触线导高、拉出值,可满足检测的需求。
In this paper,the non-contact geometric parameters detection method for contact lines based on cam-era calibration was put forward.On the platform of Software Matlab,the contact line images acquired by the CCD camera were pretreated.Then,the center point of the image laser spot was located via the iterative threshold method.Lastly,with the camera pinhole model and camera calibration,the relationship between the two-dimensional coordinates of the laser spot in the image-coordinate system and the three-dimensional space coordinates of the laser spot in the world-coordinate system was established,and the geometric parameters were calculated in accordance.The proposed method was compared with results measured with the optical measuring instrument on the same section of actual lines.The stagger difference was less than 1 1 mm and the conductor height difference was less than 10 mm.It shows that with the proposed method the height and stag-ger of the contact line can be calculated accurately and the test requirements can be satisfied.
出处
《铁道学报》
EI
CAS
CSCD
北大核心
2014年第3期25-30,共6页
Journal of the China Railway Society
基金
国家自然科学基金(U1134205
51007074)
教育部新世纪优秀人才支持计划项目(NCET-08-0825)
铁道部科技研究开发计划(2011J016-B)
关键词
摄像机标定
迭代阈值
针孔模型
导高
拉出值
camera calibration
iterative threshold
pinhole model
conductor height
stagger
作者简介
张桂南（1988-）,男,黑龙江克东人,硕士研究生.E-mail：zgn_2008@126.com
通讯作者：刘志刚（1975-）,男,河南巩义人,教授,博士.E-mail：liuzg@swjtu.cn
