期刊文献+

基于数据辅助的CPFSK信号的定时估计 被引量:3

Data aided timing estimation of CPFSK signals
在线阅读 下载PDF
导出
摘要 针对连续相位调制(CPM)信号的突发模式传输系统,提出一种基于训练序列的符号定时估计算法,并分析定时估计误差的方差修改的Cramer-Rao限(modified Cramer-Rao bound,MCRB).在传输突发包前插入一段已知的训练序列,接收端将信号进行差分、求相位后,对其进行离散傅里叶变换(DFT).符号可以定时从DFT的一次谐波分量的相位中估算得到.Matlab仿真结果表明,在加性白高斯噪声(AWGN)以及瑞利平坦衰落信道上,该算法能快速准确地估计出初始定时偏差,适用于任何进制的CPFSK信号的非相干差分接收系统,并且在实际的软件无线电平台上得到验证. A novel data aided symbol timing estimation algorithm was proposed for the transmission systems of continuous phase modulation (CPM) signals in burst mode. The modified Cramer-Rao bound (MCRB) of the timing estimation error was also analyzed. A training sequence is embedded before transmission of each packet. The receiver calculates the phase of differential signals and discrete Fourier transform (DFT). The symbol timing can be estimated from the phase of the first harmonic component of DFT outputs. Matlab simulation showed that this algorithm can estimate the initial timing error rapidly and accurately in the additive white Gaussian noise (AWGN) and the Rayleigh flat fading channels, and is suitable for noncoherent differential receiving systems of any M-ary continuous phase frequency shift keying (CPFSK) signals. The proposed algorithm was successfully testified on a software radio platform.
出处 《浙江大学学报(工学版)》 EI CAS CSCD 北大核心 2007年第12期2026-2030,共5页 Journal of Zhejiang University:Engineering Science
基金 国家自然科学基金资助项目(60602023)
关键词 连续相位调制 定时估计 离散傅里叶变换 估计误差的方差 修改的Cramer-Rao限 continuous phase modulation (CPM) timing estimation discrete Fourier transform(DFT) variance of estimation error modified Cramer-Rao bound (MCRB)
作者简介 沈文丽(1982-),女,江苏吴江人,博士生,从事MIMO-CPM系统的研究.E-mail:shenwenli@gmail.com 通讯联系人:赵民建,男,副教授.E-mail:mjzhao@ziu.edu.cn
  • 相关文献

参考文献1

二级参考文献5

  • 1Zhijian Yu, Minjian Zhao, Lifeng Liu, Peiliang Qiu. A timing recovery scheme for pulse shaped 4-CPFSK with h=0.25 [A]. Proc. of Communications 2004 and the 5th International Symposium on Multi-Dimensional Mobile Communications. 2004 Joint Conference of the 10th Asia-Pacific Conference [C]. 2004-08-09, 1: 343-346.
  • 2A Griffin, D P Taylor. On differentially demodulated CPFSK [A]. in IEEE Proc. International Conference on Communication [C]. Dallas, TX, 1996, 1: 354-358.
  • 3J B Anderson, T Aulin, C E Sundberg. Digital Phase Modulation [M]. New York: Plenum, 1986.
  • 4J P Fonseka. Baseband pulse shaping to reduce intersymbol interference in narrowband M-ary CPFSK signaling [A]. in Proc. of the 10th Annual International Conference on Computers and Communications [C]. Phoenix, 1991-03. 393-400.
  • 5R Mehlan, Y E Chen, H Meyr. A fully digital feedforward MSK demodulator with joint frequency offset and symbol timing estimation for burst mode mobile radio [J]. IEEE Trans. VT, 1993, 42(4): 434-443.

同被引文献17

  • 1Ahera Corporation. Altera Digital Library[Z]. Altera,2002.
  • 2KRAVCHENKO V F,BASARAB M A. New constructions of weight windows based on atomic functions in problems of speech-signal processing [J]. Doklady Physics,2001,46(3) :166 - 172.
  • 3QING ZHAO, STUBER G L. Robust Time and Phase Synchronization for Continuous Phase Modulation [J]. IEEE Transactions on Communications, 2006, 54(10): 1857-1869.
  • 4MORELLI M, MENGALI U, VITETTA G M. Joint Phase and Timing Recovery With CPM Signals [J]. IEEE Transactions on Communications, 1997, 45(7): 867-876.
  • 5GARDNER F M. A BPSK/QPSK Timing-Error Detector for Sampled Receivers [J]. IEEE Transactions on Communications, 1986, 34(5): 423-429.
  • 6GARDNER F M. Interpolation in Digital Modems-Part I: Fundamentals [J]. IEEE Transaetions on Communications, 1993, 41(3): 501-507.
  • 7GARDNER F M, HARRIS R A. Interpolation in Digital Modems-Part II: Implementation and Performance [J]. IEEE Transactions on Communications, 1993, 41(6): 998-1008.
  • 8ANDERSON J B, AUL1NT, SUNDBERG C E. Digital phase modulation [M]. New York: Plenum, 1986.
  • 9PROAKIS J G. Digital communications [M]. 4th ed. New York: McGraw2Hill, 2005.
  • 10潘松,黄继业,王国栋.现代DSP技术[M].西安:西安电子科技大学出版社,2004.

引证文献3

二级引证文献4

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部