期刊文献+

磁控溅射制备HA/Ti_6Al_4V复合材料种植体体外生物活性研究 被引量:1

In Vitro Bioactivity of HA/Ti_6Al_4V Composite Implant Fabricated by RF Magnetron Sputtering
在线阅读 下载PDF
导出
摘要 研究了射频磁控溅射法制备的HA/Ti6Al4V复合材料种植体在模拟体液(Simulated body fluid,SBF)环境下的生物活性。利用扫描电镜(SEM)、能谱分析(EDS)、红外光谱(FTIR)及X-射线衍射(XRD)分析了该种植体涂层在模拟体液中浸泡前后的表面形貌、界面结合状态、晶体结构和相组成的变化,结果表明:该种植体涂层在模拟体液中存在溶解和新生物质在其表面沉积相伴的过程。其中,HA涂层表面的新生物质是一种缺钙型且含有CO32-的类骨磷灰石,其n(Ca)/n(P)比值约为1.56,晶粒小,结晶度低,接近于非晶态,这与自然骨中无机相的结构成分相似,因此具有良好生物相容性和生物活性。 This is a report on the research of HA/Ti6Al4V composite implants that were successfully fabricated by radio frequency magnetron sputtering (RF-MS) technique. The mechanism and bioactivity of these implants immersed in simulated body fluid (SBF) were investigated. Changes in surface morphology, interracial bond state, crystal structure and phase composition of HA coating before and after immersing in SBF were characterized by Scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), energy dispersive spectroscopy (EDS) and X-ray diffraction (XRD), Results indicate that a new substance on the surface of HA implant coatings produces accompanying with the dissolution of coatings. The substance is bone-like apatite containing CO3^2- and lacking of Ca^2+. Its ratio of n(Ca)/n(P) is about 1.56, This substance has very small grain size and similarly amorphous structure. Its structure and composition are similar to those of natural bone. Thus, it has good biocompatibility and bioactivity.
出处 《生物医学工程学杂志》 EI CAS CSCD 北大核心 2007年第6期1319-1324,共6页 Journal of Biomedical Engineering
基金 江苏省自然科学基金资助项目(BK2003051)
关键词 HA/Ti6Al4V复合材料 种植体 模拟体液 生物活性 磁控溅射 HA/Ti6Al4V composites Implant Simulated body fluid (SBF) Bioactivity Magnetron sputtering
作者简介 通讯作者。E—mail:zhaoyt@ujs.edu.cn
  • 相关文献

参考文献12

  • 1Keller L, Dollase WA. X-ray determination of crystalline hydroxyapatite to amorphous calcium-phosphate ratio in plasma sprayed coatings. Journal of Biomedical Materials Research, 2000, 49(2) : 244.
  • 2Ding SJ, Lee TL, Chu YH. Environmental effect on bond strength of magnetron-sputtered hydroxyapatite/titanium coatings. Journal of materials Science Letters, 2003, 22 : 479.
  • 3Cotell CM. Pulsed laser deposition and processing of biocompatible hydroxylapatite thin coatings. Applied Surface Science, 1993, 69(1) : 140.
  • 4Manso M, Jimenez C, Morant C, et al. Electrodeposition of hydroxyapatite coatings in basic conditions. Biomaterials, 2000, 21(17): 1755.
  • 5Hsieh MF, Perng LH, Chin TS. Hydroxyapatite coating on Ti6Al4V alloy using a sol-gel derived precursor. Materials Chemistry and Physics, 2002, 74(3): 245.
  • 6Dijk V, Schaeken K, Wolke, et al. Influence of discharge power level on the properties of hydroxyapatite coatings deposited on Ti6Al4V with RF magnetron sputtering. Journal of Biomedical Materials Research, 1995,29 (2): 269.
  • 7张钊,赵玉涛,林东洋,张红杰.射频磁控溅射技术制备羟基磷灰石生物涂层及其微结构[J].硅酸盐学报,2004,32(7):849-853. 被引量:13
  • 8Hats K, Kokubo T, Yamamuro T. Growth bonelike apatite layer on a substrate by a biomimetic process. J Am Ceram Soc, 1995,78: 1049.
  • 9Cahn JW. 'On the Morphological Stability of Growing Crystals', Crystal Growth (Proceedings of an International Confe.rence on Crystal Growth, Boston 1966 ), Pergamon Press, New York, 1967,681-690.
  • 10段友容,吕万新,王朝元,陈继镛,张兴栋.在动态模拟体液中致密CaP陶瓷表面形貌对类骨磷灰石层形成的影响研究[J].生物医学工程学杂志,2002,19(2):186-190. 被引量:17

二级参考文献11

  • 1[1]de GROOT K,YAMAMURA T,HENCH L L,et al.Handbook of Bioactive [M].Vol Ⅱ ,Boca Raton FL: CRS Presses,1990.234-256.
  • 2[2]HA S W,MAYER J,KOCH B,et al.Plasma - sprayed hydroxylapatite coating on carbon fibre reinforced thermoplastic composite materials[J].J Mater Sci: Mater Med,1994,5(6-7): 481-484.
  • 3[3]LEE J,AOKI H.Hydroxyapatite coating on Ti plate by dipping method[J].Biomed Mater Eng,1995,14(5):49-58.
  • 4[4]SHIRKHANZADEH M.Bioactive calcium phosphate coating prepared by electrodeposition[J].Mater Lett,1991,13(10):1 415-1 417.
  • 5[5]FUJISHIRO,SATO T,OKUWAKI A,et al.Coating of hydroxyapatite on metal plates using thermal dissociation of calcium-EDTA chelate in phosphate solutions under hydrothermal conditions[J].J Mater Sci: Mater Med,1995,6(3):172-176
  • 6[6]WEN H B,WOLKE J G C,de WIJN J R,et al.Fast precipitation of calcium phosphate layers on titanium induced by simple chemical treatments [J].Biomaterials,1997,18 ( 22 ):1 471-1 478.
  • 7[7]van DIJK K,SCHAEKEN H G,WOLKE J C G,et al.Influence of discharge power level on the properties of hydroxyapatite films deposited on Ti6Al4V with RF magnetron sputtering[J].J Biomed Mater Res,1995,29(2): 269-276.
  • 8[8]DING S J,JU C P,LIN J H C,et al.Characterization of hydroxyapatite and titanium coatings sputtered on Ti6Al4V substrate[J].J Biomed Mater Res,1999,44(3): 266-279.
  • 9[9]HULBLERT S F.High Technology of Cream [M].Amsterdam :Elsevier,1987.89-213.
  • 10[10]DING S J,JU C P,LIN J H C,et al.Characterization of hydroxyapatite and titanium coatings sputtered on Ti-6Al4V substrate[J].J Biomed Mater Res,1999,44(3): 267-269.

共引文献28

同被引文献13

  • 1徐淑华,罗承萍,王迎军.羟基磷灰石生物涂层材料界面的电镜观察与分析[J].中国有色金属学报,2001,11(z2):190-194. 被引量:2
  • 2李慕勤,马臣,尚大山.亚音速火焰喷涂Y_2O_3-HA生物涂层的研究[J].中国稀土学报,2003,21(1):58-60. 被引量:2
  • 3朱振安,毛远青.骨科生物医用材料[J].生物骨科材料与临床研究,2005,2(3):21-23. 被引量:9
  • 4张玲,王芬,武秀兰.Ti/γ-TiAl/FHA生物复合涂层的制备[J].稀有金属材料与工程,2007,36(A02):43-46. 被引量:2
  • 5Kimura K. The recent titanium and titanium alloys [ J ]. Journal of the Japan Institute of Metals, 1997, (9) :62-68.
  • 6Molinari A, Straffelini G. Dry sliding wear mechanisms of the Ti6Al4V alloy [J]. Wear, 1997, 208(1) : 105-112.
  • 7Shirkhanzadeh M. XRD and XPS characterization of superplastic TiO2 coatings prepared on Ti -6Al-4V surgical alloy by an electrochemical method [ J ]. Journal of Material Science:Material In Medicine, 1995, 4(6) : 206-210.
  • 8Zeng H, Chittur K K, Lacefield W R. Dissolution/reprecipitation of calcium phosphate thin films produced by ion beam sputter deposition technique [ J ]. Biomaterials, 1999, 20(1) :443-.451.
  • 9Hsieh M F, Perng L H, Chin T S. Hydroxyapatite coating on Ti-6Al-4V alloy using a sol -gel derived precursor[ J]. Materials Chemistry and Physics, 2002, (74) :245-250.
  • 10张光磊 钟涛兴 张久兴 等.放电等离子烧结技术制备Ti合金表面HA活性涂层功能(HA activity coating sintered by spark plasma sintering on Ti alloy) .材料与器件学报,2006,9(2):205-208.

引证文献1

二级引证文献3

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部