摘要
介绍了一种按常规模压方法几乎不能成形的非同轴坯件的模压成形方法，着重介绍了模具结构设计、力学计算、结构特征及模具的动作原理。结果表明，当沿着与具有特殊形状的下冲头轴线方向成θ角的方向施压时，可完成非同轴坯件的成形。
The present paper has introduced a method of die forming non coaxial compact which is hardly formed by normal die forming method. The paper has put emphasis on the introduction of the structural design of die,mechanical calculation,structural characteristics and the action fundamental of the die. Result has shown that the formation of non coaxial compact can be completed when pressure is given along the axial direction of special shaped lower punch in a direction of forming angle. \
出处
《粉末冶金技术》
EI
CAS
CSCD
北大核心
1997年第2期113-116,共4页
Powder Metallurgy Technology
