摘要
采用自制的销盘摩擦磨损试验机,在载流条件下对铬青铜QCr0.5/T2铜的摩擦学特性进行了研究,结果表明电流对摩擦因数和磨损率具有显著影响,电流越大,磨损率越高,摩擦副磨损越严重,摩擦因数越大。载流条件下,摩擦表面发生电点蚀,并出现局部熔化和雨滴状金属颗粒。
By using self-made pin-on-disc friction and wear tester, the tribological behaviors of QCr0. 5/T2 Cu under carrying current conditions were investigated. The results indicate that electrical currents prominently influence the friction coefficient and wear rate. When the current is bigger, the wear rate is higher and the wear of counterbody become more severe and the friction coefficient increases. The tribo-surface produces electrical piting and appeares local fusion and molten raindrop metallic grain splashed after fusing under carrying current conditions.
出处
《润滑与密封》
CAS
CSCD
北大核心
2007年第4期91-93,共3页
Lubrication Engineering
基金
河南省杰出青年基金资助项目(0412002100)
国家自然科学基金资助项目(50375046)
关键词
摩擦学
磨损率
摩擦因数
载流
电点蚀
tribology
wear rate
friction coefficient
carrying current
electrical piting
作者简介
孙乐民（1965-），男，博士，副教授，主要从事摩擦磨损方面的研究．E—mail：sunlm1024@126．com．
