摘要
针对低透高突煤层群中不具备常规煤层(煤厚≥0.8 m)保护层开采条件及消除保护层遗漏煤柱下方被保护层中卸压盲区的问题,提出了极薄、薄煤层半煤岩保护层无煤柱全面卸压开采技术。基于沙曲煤矿地质条件,采用UDEC数值模拟实验分析得出:被保护煤层卸压盲区宽度随着保护层煤柱宽度的增加大致符合拟合直线方程y=17.09x-10.05的线性增长规律,拟合度R^2=0.8968;当无煤柱开采时,在原留设煤柱位置的下方被保护层中不发生垂直应力集中,即消除了卸压盲区。
In view of the problem that the low permeability and high outburst coal seam group does not have the mining condition for the protection layer of conventional coal seam(coal thickness≥0.8 m)and the ability to eliminate the blind area of pressure relief in the protected layer under the residual coal pillar,the overall pressure relief mining technology without coal pillar in the semi-coal rock protective layer of the extremely thin coal seam was proposed.Based on the geological conditions of Shaqu Coal Mine,it’s concluded by the use of UDEC numerical simulation analysis that with the increase of the width of the coal pillar of the protective layer,the width of the unloading blind zone of the protected coal seam roughly conforms to the linear growth law of the fitted linear equation y=17.09 x-10.05,and the fitting degree R^2=0.8968.When there is no pillar mining,vertical stress concentration does not occur in the protected layer below the original pillar position,that is,the blind area of unloading pressure is eliminated.
作者
谢小平
刘晓宁
梁敏富
XIE Xiaoping;LIU Xiaoning;LIANG Minfu(College of Mining and Civil Engineering of Liupanshui Normal College,Liupanshui 553004,China;Shanxi Coal Mine Safety Training Center,Taiyuan 030006,China;School of Mines,China University of Mining&Technology,Xuzhou 221116,China)
出处
《煤矿安全》
CAS
北大核心
2020年第2期208-212,共5页
Safety in Coal Mines
基金
国家自然科学基金资助项目(50504014)
贵州省煤炭绿色发展2011协同创新中心资助项目(黔教合协同创新字[2016]02号).
关键词
半煤岩
上保护层
无煤柱
卸压盲区
数值模拟实验
semi-coal rock
upper protective layer
no coal pillar
blind zone of pressure relief
numerical simulation experiment
作者简介
谢小平(1988—),男,四川泸州人,高级实验师,硕士,2014年毕业于中国矿业大学,研究方向为矿山压力与岩层控制。
