A novel fiber Bragg grating （FBG） sensor array system based on digital phase generated carrier （PGC） demodulation and reference compensation method is proposed and set up. Experimental results confirm that the dig...A novel fiber Bragg grating （FBG） sensor array system based on digital phase generated carrier （PGC） demodulation and reference compensation method is proposed and set up. Experimental results confirm that the digital PGC demodulation can be used for wavelength-division-multiplexed FBG sensor array and the reference compensation method can reduce the environmental interference by approximately 40 dB in the frequency range from 20 Hz to 2 kHz. The minimum detectable wavelength-shift of the sensor system is 1 × 10^-3 pm/Hz^1/2.展开更多
This paper presents the fundamental technique of phase generated carrier （PGC） and its realization on compact reconfigurable input and output （RIO） which adopts real-time and field programmable grate array （FPGA...This paper presents the fundamental technique of phase generated carrier （PGC） and its realization on compact reconfigurable input and output （RIO） which adopts real-time and field programmable grate array （FPGA） techniques. Improvement of the PGC technique is also introduced by using peak-to-peak value detection method to reduce the influence of variation of the light intensity. A four-element fibre Bragg gratings （FBG） laser sensor system is conducted in the experiment and the demodulated results demonstrate correlation coefficient as high as 0.995 with the reference signal and the dynamic range to be 120dB@63Hz.展开更多
External optical feedback effects due to reflection, Rayleigh backscattering and coherent Rayleigh backseattering in fiber distributed feedback （DFB） fiber laser sensor system have been investigated. If the feedback...External optical feedback effects due to reflection, Rayleigh backscattering and coherent Rayleigh backseattering in fiber distributed feedback （DFB） fiber laser sensor system have been investigated. If the feedback intensity exceeds critical amount, excess noise would be induced in the demodulator. The maximum tolerable intensity back-reflection coefficient Rc and backscattering coefficient Sc into a fiber DFB laser with lead fiber length from I m to 37.5 km before the onset of instabilities are shown. Rc is found to decrease with increasing lead fiber length while Sc was relatively invariable with varying fiber length. The coherent Rayleigh backscattering （CRBS） would induce neglectable noise with a lead fiber exceeding 13.5 kin. To eliminate these noises, one or two isolators should be incorporated in the system.展开更多
For night remote surveillance, we present a method, the range-gated laser stroboscopic imaging（RGLSI）, which uses a new kind of time delay integration mode to integrate target signals so that night remote surveillan...For night remote surveillance, we present a method, the range-gated laser stroboscopic imaging（RGLSI）, which uses a new kind of time delay integration mode to integrate target signals so that night remote surveillance can be realized by a low-energy illuminated laser. The time delay integration in this method has no influence on the video frame rate. Compared with the traditional range-gated laser imaging, RGLSI can reduce scintillation and target speckle effects and significantly improve the image signal-to-noise ratio analyzed. Even under low light level and low visibility conditions, the RGLSI system can effectively work. In a preliminary experiment, we have detected and recognized a railway bridge one kilometer away under a visibility of six kilometers, when the effective illuminated energy is 29.5μl.展开更多
In four-dimensional flash trajectory imaging,temporal parameters include time delay,laser pulse width,gate time,pulse pair repetition frequency and the frame rate of CCD,which directly impact on the acquisition of tar...In four-dimensional flash trajectory imaging,temporal parameters include time delay,laser pulse width,gate time,pulse pair repetition frequency and the frame rate of CCD,which directly impact on the acquisition of target trajectories over time.We propose a method of optimizing the temporal parameters of flash trajectory imaging.All the temporal parameters can be estimated by the spatial parameters of the volumes of interest,target scale and velocity,and target sample number.The formulae for optimizing temporal parameters are derived,and the method is demonstrated in an experiment with a ball oscillating as a pendulum.展开更多
基金supported by the National 863 Program under Grant No. 2007AA03Z415.
文摘A novel fiber Bragg grating （FBG） sensor array system based on digital phase generated carrier （PGC） demodulation and reference compensation method is proposed and set up. Experimental results confirm that the digital PGC demodulation can be used for wavelength-division-multiplexed FBG sensor array and the reference compensation method can reduce the environmental interference by approximately 40 dB in the frequency range from 20 Hz to 2 kHz. The minimum detectable wavelength-shift of the sensor system is 1 × 10^-3 pm/Hz^1/2.
基金supported by the National 863 Program under Grant No 2007AA03Z415.
文摘This paper presents the fundamental technique of phase generated carrier （PGC） and its realization on compact reconfigurable input and output （RIO） which adopts real-time and field programmable grate array （FPGA） techniques. Improvement of the PGC technique is also introduced by using peak-to-peak value detection method to reduce the influence of variation of the light intensity. A four-element fibre Bragg gratings （FBG） laser sensor system is conducted in the experiment and the demodulated results demonstrate correlation coefficient as high as 0.995 with the reference signal and the dynamic range to be 120dB@63Hz.
基金supported by the National 863 Program under Grant No. 2007AA03Z415.
文摘External optical feedback effects due to reflection, Rayleigh backscattering and coherent Rayleigh backseattering in fiber distributed feedback （DFB） fiber laser sensor system have been investigated. If the feedback intensity exceeds critical amount, excess noise would be induced in the demodulator. The maximum tolerable intensity back-reflection coefficient Rc and backscattering coefficient Sc into a fiber DFB laser with lead fiber length from I m to 37.5 km before the onset of instabilities are shown. Rc is found to decrease with increasing lead fiber length while Sc was relatively invariable with varying fiber length. The coherent Rayleigh backscattering （CRBS） would induce neglectable noise with a lead fiber exceeding 13.5 kin. To eliminate these noises, one or two isolators should be incorporated in the system.
文摘For night remote surveillance, we present a method, the range-gated laser stroboscopic imaging（RGLSI）, which uses a new kind of time delay integration mode to integrate target signals so that night remote surveillance can be realized by a low-energy illuminated laser. The time delay integration in this method has no influence on the video frame rate. Compared with the traditional range-gated laser imaging, RGLSI can reduce scintillation and target speckle effects and significantly improve the image signal-to-noise ratio analyzed. Even under low light level and low visibility conditions, the RGLSI system can effectively work. In a preliminary experiment, we have detected and recognized a railway bridge one kilometer away under a visibility of six kilometers, when the effective illuminated energy is 29.5μl.
文摘In four-dimensional flash trajectory imaging,temporal parameters include time delay,laser pulse width,gate time,pulse pair repetition frequency and the frame rate of CCD,which directly impact on the acquisition of target trajectories over time.We propose a method of optimizing the temporal parameters of flash trajectory imaging.All the temporal parameters can be estimated by the spatial parameters of the volumes of interest,target scale and velocity,and target sample number.The formulae for optimizing temporal parameters are derived,and the method is demonstrated in an experiment with a ball oscillating as a pendulum.
