The typical development of total volumetric change in the focal areas of seismic events,corresponding to destress blasting,is characterized as an explosive phase followed by an implosive phase and with alternating add...The typical development of total volumetric change in the focal areas of seismic events,corresponding to destress blasting,is characterized as an explosive phase followed by an implosive phase and with alternating additional phases following on from that.In a few cases,a non-typical development of volumetric change was identified,where the first phase was implosive and the second phase,explosive.This development is mainly typical for induced seismic events recorded during mining,not for destress blasting.Seismic events were recorded during longwall mining in the Czech part of the Upper Silesian Coal Basin,where the destress blasting technique is used as a rockburst prevention active measure.Kinematic source processes in the focal areas of selected seismic events were analyzed by the seismic moment tensor inversion method,as well as by studying geomechanical rock mass conditions at the localities of the seismic events.The main goal of the analysis was to attempt to identify the reasons for non-typical development of volumetric changes in these cases.Volumetric changes were analyzed for seismic events with energy greater than 104 J,recorded in the period of time from 1993 to 2009(1109 events).80%(891)of the recorded seismic events were induced seismic events that were registered during longwall mining and 20%(218)corresponded to destress blasting events.Research shows that the main reason for the non-typical development of volumetric changes in the focal areas of seismic events is an association with destress blasting in the rock mass,which is very close to rock mass overstressing.The detonation of explosives in boreholes,which would dominate the first phase of volumetric changes,probably obscured stress release in the rock mass,as manifested in the first implosion phase of the volumetric changes in this case.展开更多
Some electrical parameters of the SIS-type hysteretic underdamped Josephson junction(JJ)can be measured by its current-voltage characteristics(IVCs).Currents and voltages at JJ are commensurate with the intrinsic nois...Some electrical parameters of the SIS-type hysteretic underdamped Josephson junction(JJ)can be measured by its current-voltage characteristics(IVCs).Currents and voltages at JJ are commensurate with the intrinsic noise level of measuring instruments.This leads to the need for multiple measurements with subsequent statistical processing.In this paper,the digital algorithms are proposed for the automatic measurement of the JJ parameters by IVC.These algorithms make it possible to implement multiple measurements and check these JJ parameters in an automatic mode with the required accuracy.The complete sufficient statistics are used to minimize the root-mean-square error of parameter measurement.A sequence of current pulses with slow rising and falling edges is used to drive JJ,and synchronous current and voltage readings at JJ are used to realize measurement algorithms.The algorithm performance is estimated through computer simulations.The significant advantage of the proposed algorithms is the independence from current source noise and intrinsic noise of current and voltage meters,as well as the simple implementation in automatic digital measuring systems.The proposed algorithms can be used to control JJ parameters during mass production of superconducting integrated circuits,which will improve the production efficiency and product quality.展开更多
A better understanding of gas-solid coupling laws for deep, gassy coal seams is vital for preventing the compound dynamic disasters such as rock burst and gas outburst. In this paper, a gas-solid coupling theoretical ...A better understanding of gas-solid coupling laws for deep, gassy coal seams is vital for preventing the compound dynamic disasters such as rock burst and gas outburst. In this paper, a gas-solid coupling theoretical model under the influence of ground stress, gas pressure, and mining depth is established and simulated by using COMSOL Multiphysics software. Research results indicate that under the influence of factors such as high ground stress and gas pressure, the mutual coupling interaction between coal and gas is much more significant, which leads to the emergence of new characteristics of gas compound dynamic disasters. Reducing the ground stress concentration in front of the working face can not only minimize the possibility of rock burst accidents, which are mainly caused by ground stress, but also can weaken the role of ground stress as a barrier to gas, thereby decreasing the number of outburst accidents whose dominant factor is gas. The results have a great theoretical and practical significance in terms of accident prevention, enhanced mine safety, disaster prevention system design, and improved accident emergency plans.展开更多
基金the project of the Institute of Clean Technologies for Mining and Utilisation of Raw Materials for Energy Use–Sustainability Programme(No.LO1406)supported by a project for the long-term conceptual development of research organisations(No.RVO68145535)
文摘The typical development of total volumetric change in the focal areas of seismic events,corresponding to destress blasting,is characterized as an explosive phase followed by an implosive phase and with alternating additional phases following on from that.In a few cases,a non-typical development of volumetric change was identified,where the first phase was implosive and the second phase,explosive.This development is mainly typical for induced seismic events recorded during mining,not for destress blasting.Seismic events were recorded during longwall mining in the Czech part of the Upper Silesian Coal Basin,where the destress blasting technique is used as a rockburst prevention active measure.Kinematic source processes in the focal areas of selected seismic events were analyzed by the seismic moment tensor inversion method,as well as by studying geomechanical rock mass conditions at the localities of the seismic events.The main goal of the analysis was to attempt to identify the reasons for non-typical development of volumetric changes in these cases.Volumetric changes were analyzed for seismic events with energy greater than 104 J,recorded in the period of time from 1993 to 2009(1109 events).80%(891)of the recorded seismic events were induced seismic events that were registered during longwall mining and 20%(218)corresponded to destress blasting events.Research shows that the main reason for the non-typical development of volumetric changes in the focal areas of seismic events is an association with destress blasting in the rock mass,which is very close to rock mass overstressing.The detonation of explosives in boreholes,which would dominate the first phase of volumetric changes,probably obscured stress release in the rock mass,as manifested in the first implosion phase of the volumetric changes in this case.
基金the Ministry of Science and Higher Education of the Russian Federation under Grant No.FSUN-2023-0007.
文摘Some electrical parameters of the SIS-type hysteretic underdamped Josephson junction(JJ)can be measured by its current-voltage characteristics(IVCs).Currents and voltages at JJ are commensurate with the intrinsic noise level of measuring instruments.This leads to the need for multiple measurements with subsequent statistical processing.In this paper,the digital algorithms are proposed for the automatic measurement of the JJ parameters by IVC.These algorithms make it possible to implement multiple measurements and check these JJ parameters in an automatic mode with the required accuracy.The complete sufficient statistics are used to minimize the root-mean-square error of parameter measurement.A sequence of current pulses with slow rising and falling edges is used to drive JJ,and synchronous current and voltage readings at JJ are used to realize measurement algorithms.The algorithm performance is estimated through computer simulations.The significant advantage of the proposed algorithms is the independence from current source noise and intrinsic noise of current and voltage meters,as well as the simple implementation in automatic digital measuring systems.The proposed algorithms can be used to control JJ parameters during mass production of superconducting integrated circuits,which will improve the production efficiency and product quality.
基金financially supported by the State Key Research Development Program of China (Nos. 2016YFC0801402, 2016YFC0600708)the National Natural Science Foundation of China (Nos. 51474219, 51304213)
文摘A better understanding of gas-solid coupling laws for deep, gassy coal seams is vital for preventing the compound dynamic disasters such as rock burst and gas outburst. In this paper, a gas-solid coupling theoretical model under the influence of ground stress, gas pressure, and mining depth is established and simulated by using COMSOL Multiphysics software. Research results indicate that under the influence of factors such as high ground stress and gas pressure, the mutual coupling interaction between coal and gas is much more significant, which leads to the emergence of new characteristics of gas compound dynamic disasters. Reducing the ground stress concentration in front of the working face can not only minimize the possibility of rock burst accidents, which are mainly caused by ground stress, but also can weaken the role of ground stress as a barrier to gas, thereby decreasing the number of outburst accidents whose dominant factor is gas. The results have a great theoretical and practical significance in terms of accident prevention, enhanced mine safety, disaster prevention system design, and improved accident emergency plans.
