Abstract:The aim of this research is to design and operate a 10 kW hot chemical-looping gasification(CLG)unit using Fe2O3/Al2O3as an oxygen carrier and saw dust as a fuel.The effect of the operation temperature on gas...Abstract:The aim of this research is to design and operate a 10 kW hot chemical-looping gasification(CLG)unit using Fe2O3/Al2O3as an oxygen carrier and saw dust as a fuel.The effect of the operation temperature on gas composition in the air reactor and the fuel reactor,and the carbon conversion of biomass to CO2and CO in the fuel reactor have been experimentally studied.A total60 h run has been obtained with the same batch of oxygen carrier of iron oxide supported with alumina.The results show that CO and H2concentrations are increased with increasing temperature in the fuel reactor.It is also found that with increasing fuel reactor temperature,both the amount of residual char in the fuel reactor and CO2concentration of the exit gas from the air reactor are degreased.Carbon conversion rate and gasification efficiency are increased by increasing temperature and H2production at 870℃reaches the highest rate.Scanning electron microscopy(SEM),X-ray diffraction(XRD)and BET-surface area tests have been used to characterize fresh and reacted oxygen carrier particles.The results display that the oxygen carrier activity is not declined and the specific surface area of the oxygen carrier particles is not decreased significantly.展开更多
A 40-60 t/h modularized dry coal beneficiation process with a novel method to control the bed was designed around a gas-solid fluidized bed separator. Furthermore, the hydrodynamics of medium-solids consisting of wide...A 40-60 t/h modularized dry coal beneficiation process with a novel method to control the bed was designed around a gas-solid fluidized bed separator. Furthermore, the hydrodynamics of medium-solids consisting of wide-size-range magnetite powder （0.3-0.06 ram） and 〈1 mm fine coal were numerically studied. The simulation results show that the fluidization performance of the wide-size-range medium-solid bed is good. The separation performance of the modularized system was then investigated in detail using a mixture of 〈0.3 mm magnetite powder （mass fraction of 0.3-0.06 mm particles is 91.38 %） and 〈1 mm fine coal as solid media. The experimental results show that at separation densities of 1.33 g/cm^3 or 1.61 g/cm^3, 50-6 mm coal can be separated effectively with probable error, E, values of 0.05 g/cm^3 and 0.06 g/cm^3, respectively. This technique is beneficial for saving water resources and for the clean utilization of coal.展开更多
A comparative study of the influence of elevated temperature on foam geopolymer using circulating fluidized bed combustion fly ash（CFA） was reported. Foam geopoymers were prepared with different amounts of foam agen...A comparative study of the influence of elevated temperature on foam geopolymer using circulating fluidized bed combustion fly ash（CFA） was reported. Foam geopoymers were prepared with different amounts of foam agent and different Si O2/Al2O3 molar ratios of 3.1, 3.4, and 3.8. The mechanical, thermo-physical properties and microstructure of the foam geopolymers before and after exposure to elevated temperature of 800, 1000, and 1200 ℃ were investigated. The specimen with Si O2/Al2O3 molar ratio of 3.8 exhibits the highest compressive strength, better microstructure and dimension stability before and after firing. Carnegeite, nepheline, and zeolite crystalline phases appearing after exposure may contribute to the good post-exposure strength. Low weight foam geopolymer using CFA can increase strength and maintain higher stability as high as 1000 ℃.展开更多
This paper presents a robust model reference adaptive control scheme to deal with un-certain time delay in the dynamical model of a ?uidized bed combustor for sewage sludge. Thetheoretical analysis and simulation resu...This paper presents a robust model reference adaptive control scheme to deal with un-certain time delay in the dynamical model of a ?uidized bed combustor for sewage sludge. Thetheoretical analysis and simulation results show that the proposed scheme can guarantee not onlystability and robustness, but also the adaptive decoupling performance of the system.展开更多
The mechanism of beneficiation with air dense fluidized bed has been theoretically studied in the paper. Focusing attention on the misplacing resources in separation process, the misplacing effects are divided into t...The mechanism of beneficiation with air dense fluidized bed has been theoretically studied in the paper. Focusing attention on the misplacing resources in separation process, the misplacing effects are divided into two parts called respectively as misplacing effect of viscosity and misplacing effect of motion. The proposed separation theory can reasonably explain the results of separation in different fluidization states. Experimental results in pilot and commercial plants showed that the air dense medium fluidized bed is a high efficiency dry cleaning technique. The dynamic stability of fluidized bed density is directly affected by the variation of fine coal content in fluidized bed and can be controlled in expected range through measurement of fluidized bed density and adjusting of split flow rate. With air dense medium fluidized bed, various coals of size 50—6 mm can be efficiently beneficiated. The separation density can be adjusted between 1.2—2.2 g/cm 3, and the probable error E p value is about 0.06.展开更多
基金Supported by the National Natural Science Foundation of China(51076154)National Key Technology Research&Development Program of 12 th Five-year of China(2011BAD15B05)
文摘Abstract:The aim of this research is to design and operate a 10 kW hot chemical-looping gasification(CLG)unit using Fe2O3/Al2O3as an oxygen carrier and saw dust as a fuel.The effect of the operation temperature on gas composition in the air reactor and the fuel reactor,and the carbon conversion of biomass to CO2and CO in the fuel reactor have been experimentally studied.A total60 h run has been obtained with the same batch of oxygen carrier of iron oxide supported with alumina.The results show that CO and H2concentrations are increased with increasing temperature in the fuel reactor.It is also found that with increasing fuel reactor temperature,both the amount of residual char in the fuel reactor and CO2concentration of the exit gas from the air reactor are degreased.Carbon conversion rate and gasification efficiency are increased by increasing temperature and H2production at 870℃reaches the highest rate.Scanning electron microscopy(SEM),X-ray diffraction(XRD)and BET-surface area tests have been used to characterize fresh and reacted oxygen carrier particles.The results display that the oxygen carrier activity is not declined and the specific surface area of the oxygen carrier particles is not decreased significantly.
基金Projects(50921002, 50774084) supported by the National Natural Science Foundation of ChinaProject(2007AA05Z318) supported by the National High-tech Research and Development Program of China+1 种基金Project(BK2010002) supported by the Natural Science Foundation of Jiangsu Province of ChinaProject(20100480473) supported by the China Postdoctoral Science Foundation
文摘A 40-60 t/h modularized dry coal beneficiation process with a novel method to control the bed was designed around a gas-solid fluidized bed separator. Furthermore, the hydrodynamics of medium-solids consisting of wide-size-range magnetite powder （0.3-0.06 ram） and 〈1 mm fine coal were numerically studied. The simulation results show that the fluidization performance of the wide-size-range medium-solid bed is good. The separation performance of the modularized system was then investigated in detail using a mixture of 〈0.3 mm magnetite powder （mass fraction of 0.3-0.06 mm particles is 91.38 %） and 〈1 mm fine coal as solid media. The experimental results show that at separation densities of 1.33 g/cm^3 or 1.61 g/cm^3, 50-6 mm coal can be separated effectively with probable error, E, values of 0.05 g/cm^3 and 0.06 g/cm^3, respectively. This technique is beneficial for saving water resources and for the clean utilization of coal.
基金Project(20120023110011) supported by Doctoral Program of Higher Education of ChinaProjects(2009KH09,2009QH02) supported by the Fundamental Research Funds for the Central Universities of China
文摘A comparative study of the influence of elevated temperature on foam geopolymer using circulating fluidized bed combustion fly ash（CFA） was reported. Foam geopoymers were prepared with different amounts of foam agent and different Si O2/Al2O3 molar ratios of 3.1, 3.4, and 3.8. The mechanical, thermo-physical properties and microstructure of the foam geopolymers before and after exposure to elevated temperature of 800, 1000, and 1200 ℃ were investigated. The specimen with Si O2/Al2O3 molar ratio of 3.8 exhibits the highest compressive strength, better microstructure and dimension stability before and after firing. Carnegeite, nepheline, and zeolite crystalline phases appearing after exposure may contribute to the good post-exposure strength. Low weight foam geopolymer using CFA can increase strength and maintain higher stability as high as 1000 ℃.
基金Supported by National Natural Science Foundation of P.R.China(60374001,60334030)the Chinese Ministry of Education(20030006003)
文摘This paper presents a robust model reference adaptive control scheme to deal with un-certain time delay in the dynamical model of a ?uidized bed combustor for sewage sludge. Thetheoretical analysis and simulation results show that the proposed scheme can guarantee not onlystability and robustness, but also the adaptive decoupling performance of the system.
文摘The mechanism of beneficiation with air dense fluidized bed has been theoretically studied in the paper. Focusing attention on the misplacing resources in separation process, the misplacing effects are divided into two parts called respectively as misplacing effect of viscosity and misplacing effect of motion. The proposed separation theory can reasonably explain the results of separation in different fluidization states. Experimental results in pilot and commercial plants showed that the air dense medium fluidized bed is a high efficiency dry cleaning technique. The dynamic stability of fluidized bed density is directly affected by the variation of fine coal content in fluidized bed and can be controlled in expected range through measurement of fluidized bed density and adjusting of split flow rate. With air dense medium fluidized bed, various coals of size 50—6 mm can be efficiently beneficiated. The separation density can be adjusted between 1.2—2.2 g/cm 3, and the probable error E p value is about 0.06.
