The effects of fire exposure,reinforcement ratio and the presence of axial load under fire on the seismic behavior of reinforced concrete(RC) shear walls were investigated.Five RC shear walls were tested under low cyc...The effects of fire exposure,reinforcement ratio and the presence of axial load under fire on the seismic behavior of reinforced concrete(RC) shear walls were investigated.Five RC shear walls were tested under low cyclic loading.Prior to the cyclic test,three specimens were exposed to fire and two of them were also subjected to a constant axial load.Test results indicate that the ultimate load of the specimen with lower reinforcement ratio is reduced by 15.8%after exposure to elevated temperatures.While the reductions in the energy dissipation and initial stiffness are 59.2%and 51.8%,respectively,which are much higher than those in the ultimate load.However,this deterioration can be slowed down by properly increasing reinforcement due to the strength and stiffness recovery of steel bars after cooling.In addition,the combined action of elevated temperatures and axial load results in more energy dissipation than the action of fire exposure alone.展开更多
The deformation performance index limits of high reinforced concrete （RC） shear wall components based on Chinese codes were discussed by the nonlinear finite element method. Two typical RC shear wall specimens in th...The deformation performance index limits of high reinforced concrete （RC） shear wall components based on Chinese codes were discussed by the nonlinear finite element method. Two typical RC shear wall specimens in the previous work were first used to verify the correctness of the nonlinear finite element method. Then, the nonlinear finite element method was applied to study the deformability of a set of high RC shear wall components designed according to current Chinese codes and with shear span ratio λ≥2.0. Parametric studies were made on the influence of shear span ratio, axial compression ratio, ratio of flexural capacity to shear capacity and main flexural reinforcement ratio of confined botmdary members. Finally, the deformation performance index and its limits of high RC shear wall components under severe earthquakes were proposed by the finite element model results, which offers a reference in determining the performance status of RC shear wall components designed based on Chinese codes.展开更多
Reinforced concrete(RC) load bearing wall is widely used in high-rise and mid-rise buildings. Due to the number of walls in plan and reduction in lateral force portion, this system is not only stronger against earthqu...Reinforced concrete(RC) load bearing wall is widely used in high-rise and mid-rise buildings. Due to the number of walls in plan and reduction in lateral force portion, this system is not only stronger against earthquakes, but also more economical. The effect of progressive collapse caused by removal of load bearing elements, in various positions in plan and stories of the RC load bearing wall system was evaluated by nonlinear dynamic and static analyses. For this purpose, three-dimensional model of 10-story structure was selected. The analysis results indicated stability, strength and stiffness of the RC load-bearing wall system against progressive collapse. It was observed that the most critical condition for removal of load bearing walls was the instantaneous removal of the surrounding walls located at the corners of the building where the sections of the load bearing elements were changed. In this case, the maximum vertical displacement was limited to 6.3 mm and the structure failed after applying the load of 10 times the axial load bored by removed elements. Comparison between the results of the nonlinear dynamic and static analyses demonstrated that the "load factor" parameter was a reasonable criterion to evaluate the progressive collapse potential of the structure.展开更多
In order to get the formulae for calculating the equivalent frame width coefficient of reinforced concrete hollow slab-column structures with edge beam,the finite element structural program was used in the elastic ana...In order to get the formulae for calculating the equivalent frame width coefficient of reinforced concrete hollow slab-column structures with edge beam,the finite element structural program was used in the elastic analysis of reinforced concrete hollow slab-column structure with different dimensions to study internal relationship between effective beam width and the frame dimensions.In addition,the formulas for calculating the increasing coefficient of edge beam were also obtained.展开更多
爆炸作用下地面建筑目标的破坏分析对制定实战打击策略和工程防护具有重要的实践指导意义。采用LS-DYNA有限元分析软件对已有含填充墙钢筋混凝土(reinforced concrete,RC)框架结构的近区爆炸试验进行复现,充分验证了所采用的精细化数值...爆炸作用下地面建筑目标的破坏分析对制定实战打击策略和工程防护具有重要的实践指导意义。采用LS-DYNA有限元分析软件对已有含填充墙钢筋混凝土(reinforced concrete,RC)框架结构的近区爆炸试验进行复现,充分验证了所采用的精细化数值仿真方法的适用性。结合建筑结构混合单元建模方法,对典型三层含填充墙RC框架结构在典型战斗部(100 kg和200 kg TNT当量)爆炸作用下的动态响应开展了仿真分析,考察了爆炸波在结构内部的传播和结构损伤特性。基于等效单自由度(single-degree-of-freedom,SDOF)方法预测了爆炸荷载作用下框架结构梁、柱、板和填充墙等构件的损伤等级,建立了内爆炸作用下建筑目标的破坏简化分析方法,并通过与精细化数值仿真结果对比检验其适用性。结果表明,在100 kg和200 kg TNT爆炸工况下,精细化数值仿真分析中建筑物整体功能性和结构性毁伤等级均为中度和轻度,等效SDOF简化分析得到的相应毁伤等级与数值仿真结果一致。此外,从各构件的毁伤等级可以看出,相比于板、梁和柱等承重构件,砌体填充墙更易发生破坏,从而导致爆炸波在层内水平方向房间的毁伤破坏范围更大。展开更多
基金Project(200801410005) supported by Doctoral Foundation of Ministry of Education of China
文摘The effects of fire exposure,reinforcement ratio and the presence of axial load under fire on the seismic behavior of reinforced concrete(RC) shear walls were investigated.Five RC shear walls were tested under low cyclic loading.Prior to the cyclic test,three specimens were exposed to fire and two of them were also subjected to a constant axial load.Test results indicate that the ultimate load of the specimen with lower reinforcement ratio is reduced by 15.8%after exposure to elevated temperatures.While the reductions in the energy dissipation and initial stiffness are 59.2%and 51.8%,respectively,which are much higher than those in the ultimate load.However,this deterioration can be slowed down by properly increasing reinforcement due to the strength and stiffness recovery of steel bars after cooling.In addition,the combined action of elevated temperatures and axial load results in more energy dissipation than the action of fire exposure alone.
基金Project(2009ZA04) supported by the Independent Research Foundation of State Key Laboratory of Subtropical Architecture Science,China
文摘The deformation performance index limits of high reinforced concrete （RC） shear wall components based on Chinese codes were discussed by the nonlinear finite element method. Two typical RC shear wall specimens in the previous work were first used to verify the correctness of the nonlinear finite element method. Then, the nonlinear finite element method was applied to study the deformability of a set of high RC shear wall components designed according to current Chinese codes and with shear span ratio λ≥2.0. Parametric studies were made on the influence of shear span ratio, axial compression ratio, ratio of flexural capacity to shear capacity and main flexural reinforcement ratio of confined botmdary members. Finally, the deformation performance index and its limits of high RC shear wall components under severe earthquakes were proposed by the finite element model results, which offers a reference in determining the performance status of RC shear wall components designed based on Chinese codes.
文摘Reinforced concrete(RC) load bearing wall is widely used in high-rise and mid-rise buildings. Due to the number of walls in plan and reduction in lateral force portion, this system is not only stronger against earthquakes, but also more economical. The effect of progressive collapse caused by removal of load bearing elements, in various positions in plan and stories of the RC load bearing wall system was evaluated by nonlinear dynamic and static analyses. For this purpose, three-dimensional model of 10-story structure was selected. The analysis results indicated stability, strength and stiffness of the RC load-bearing wall system against progressive collapse. It was observed that the most critical condition for removal of load bearing walls was the instantaneous removal of the surrounding walls located at the corners of the building where the sections of the load bearing elements were changed. In this case, the maximum vertical displacement was limited to 6.3 mm and the structure failed after applying the load of 10 times the axial load bored by removed elements. Comparison between the results of the nonlinear dynamic and static analyses demonstrated that the "load factor" parameter was a reasonable criterion to evaluate the progressive collapse potential of the structure.
文摘In order to get the formulae for calculating the equivalent frame width coefficient of reinforced concrete hollow slab-column structures with edge beam,the finite element structural program was used in the elastic analysis of reinforced concrete hollow slab-column structure with different dimensions to study internal relationship between effective beam width and the frame dimensions.In addition,the formulas for calculating the increasing coefficient of edge beam were also obtained.
文摘爆炸作用下地面建筑目标的破坏分析对制定实战打击策略和工程防护具有重要的实践指导意义。采用LS-DYNA有限元分析软件对已有含填充墙钢筋混凝土(reinforced concrete,RC)框架结构的近区爆炸试验进行复现,充分验证了所采用的精细化数值仿真方法的适用性。结合建筑结构混合单元建模方法,对典型三层含填充墙RC框架结构在典型战斗部(100 kg和200 kg TNT当量)爆炸作用下的动态响应开展了仿真分析,考察了爆炸波在结构内部的传播和结构损伤特性。基于等效单自由度(single-degree-of-freedom,SDOF)方法预测了爆炸荷载作用下框架结构梁、柱、板和填充墙等构件的损伤等级,建立了内爆炸作用下建筑目标的破坏简化分析方法,并通过与精细化数值仿真结果对比检验其适用性。结果表明,在100 kg和200 kg TNT爆炸工况下,精细化数值仿真分析中建筑物整体功能性和结构性毁伤等级均为中度和轻度,等效SDOF简化分析得到的相应毁伤等级与数值仿真结果一致。此外,从各构件的毁伤等级可以看出,相比于板、梁和柱等承重构件,砌体填充墙更易发生破坏,从而导致爆炸波在层内水平方向房间的毁伤破坏范围更大。
