期刊文献+
共找到4篇文章
< 1 >
每页显示 20 50 100
N-烷基取代丙烯酰胺类三嵌段共聚物的温敏性聚集行为 被引量:1
1
作者 刘新普 曹亚 《高分子材料科学与工程》 EI CAS CSCD 北大核心 2011年第9期40-43,共4页
利用原子力显微镜对两种温敏性不同嵌段序列N-异丙基丙烯酰胺(NIPAM)与N,N-二甲基丙烯酰胺(DMA)的三嵌段共聚物P(DMA32-b-NIPAM166-b-DMA32)、P(NIPAM65-b-DMA30-b-NIPAM53)溶液的聚集形貌进行了研究,前者在15℃不同质量浓度均以单分子... 利用原子力显微镜对两种温敏性不同嵌段序列N-异丙基丙烯酰胺(NIPAM)与N,N-二甲基丙烯酰胺(DMA)的三嵌段共聚物P(DMA32-b-NIPAM166-b-DMA32)、P(NIPAM65-b-DMA30-b-NIPAM53)溶液的聚集形貌进行了研究,前者在15℃不同质量浓度均以单分子线团聚集,50℃时1.0 g/L形成胶束间大聚集体,直径约为3.3μm,降低质量浓度至0.1g/L及以下则形成多分子胶束,但无胶束间聚集体形成。后者在15℃、50℃,1.0 g/L质量浓度均形成胶束间聚集体,降低质量浓度至0.1 g/L、0.01 g/L则只形成多分子胶束,胶束直径约60 nm^90 nm。 展开更多
关键词 n-烷基取代丙烯酰胺 三嵌段共聚物 原子力显微镜 温敏性 聚集形貌
在线阅读 下载PDF
酸碱电导滴定法测定N-十二烷基壳聚糖取代度 被引量:2
2
作者 罗菊香 李幼华 +1 位作者 郑洹 董美红 《食品工业科技》 CAS CSCD 北大核心 2014年第7期268-271,共4页
本文利用NaOH标准溶液滴定溶解于过量HCl溶液中的N-十二烷基壳聚糖样品,研究了酸碱滴定中N-十二烷基壳聚糖溶液电导率值的变化,通过测定电导率值,计算烷基壳聚糖的取代度。该方法的相对标准偏差为1.37%,改变测试条件,取代度值无显著性差... 本文利用NaOH标准溶液滴定溶解于过量HCl溶液中的N-十二烷基壳聚糖样品,研究了酸碱滴定中N-十二烷基壳聚糖溶液电导率值的变化,通过测定电导率值,计算烷基壳聚糖的取代度。该方法的相对标准偏差为1.37%,改变测试条件,取代度值无显著性差异(p>0.05)。该方法具有操作简便、准确可靠、重复性好等优点。 展开更多
关键词 电导滴定法 n-十二烷基壳聚糖 取代
在线阅读 下载PDF
N-烷基取代烯胺合成方法研究 被引量:1
3
作者 易兵 谢治民 杨辉琼 《化学研究与应用》 CAS CSCD 北大核心 2006年第12期1453-1455,共3页
本文研究了一种通用的N-烷基取代烯胺合成方法。着重探讨了反应物配比、催化剂用量、反应时间等条件对缩合反应的影响。在优化的工艺条件下,能获得纯度较好,收率较高的N-烷基取代烯胺。
关键词 n-烷基取代烯胺 合成
在线阅读 下载PDF
Relationship between the Composition of Polymer of n-Alkyl Substituted Acrylate and Vinyl Amine and Their Performance on Pour Point Depression
4
作者 Jiang Qingzhe Luo Fangmin Song Zhaozheng Ke Ming 《China Petroleum Processing & Petrochemical Technology》 SCIE CAS 2005年第3期27-32,共6页
Polymer of n-alkyl substituted acrylate (PA) with the alkyl side chains C16- 30 were synthesized. Their crystallinity, solubility and effect on pour point depression were studied. Results showed that only carbon ato... Polymer of n-alkyl substituted acrylate (PA) with the alkyl side chains C16- 30 were synthesized. Their crystallinity, solubility and effect on pour point depression were studied. Results showed that only carbon atoms located far away from polar groups of PAL pour point depressants participated in crystallization. When the number of carbon atoms that participated in crystallization is about three fourths of the average carbon number of wax in crude, the effect of PA is the best. The molecular weight distribution of PA pour point depressant has little influence on the effect of pour point depression, and the average molecular weight of PA in the range of ( 1.5- 2.2)× 10^4 shows the best effect. The introduction of polar groups into the molecule of PA can improve its performance. However, a too high content of polar groups in PA would cause deterioration, and even lead to loss of PA's performance for pour point depression. 展开更多
关键词 POLYACRYLATES molecular weight distribution pour point depression
在线阅读 下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部