The rheological properties of two kinds of oil-based drilling fluids with typically composition were studied at pressures up to 138 MPa and temperatures up to 204 ℃ using the RheoChan 7400 Rheometer.The experimental ...The rheological properties of two kinds of oil-based drilling fluids with typically composition were studied at pressures up to 138 MPa and temperatures up to 204 ℃ using the RheoChan 7400 Rheometer.The experimental results show that the apparent viscosity,plastic viscosity and yield point decrease with the increase of temperature,and increase with the increase of pressure.The effect of pressure on the apparent viscosity,plastic viscosity and yield point is considerable at ambient temperature.However,this effect gradually reduces with the increase of temperature.The major factor influencing the rheological properties of oil-based drilling fluids is temperature instead of pressure in the deep sections of oil wells.On the basis of numerous experiments,the model for predict the apparent viscosity,plastic viscosity and yield point of oil-based drilling fluids at high temperature and pressure was established using the method of regressive analysis.It is confirmed that the calculated data are in good agreement with the measured data,and the correlation coefficients are more than 0.98.The model is convenient for use and suitable for the application in drilling operations.展开更多
A regrown composite fiber was synthesized during the sintering of diamond under high pressure 5.8 GPa and high temperature 1500℃for 1 min,using 3wt%MWCNTs as additive.SEM observation of the fiber after alkali and aci...A regrown composite fiber was synthesized during the sintering of diamond under high pressure 5.8 GPa and high temperature 1500℃for 1 min,using 3wt%MWCNTs as additive.SEM observation of the fiber after alkali and acid treatment revealed that the outer layer of the fiber is composed of nano-polycrystalline diamond.EDS,XPS,XRD and Raman spectrum analysis further identified that the fiber is composed of MWCNTs in the inner part and nano-polycrystalline diamond in the out layer.It is proposed that the untransformed MWCNTs may act as a template for the regrown outer layer of nano diamond fiber under high pressure and high temperature.展开更多
Experimental and theoretical researches on the doping effect of interface binding state with homologous and heterogeneous dopants(d) in the system of PCD etc,as well as the action of intermediate layers between D /d a...Experimental and theoretical researches on the doping effect of interface binding state with homologous and heterogeneous dopants(d) in the system of PCD etc,as well as the action of intermediate layers between D /d at superhigh pressure and high temperature(HP-HT) are reported in this paper.展开更多
Cubic boron nitride(CBN) composites starting with CBN-Al mixtures were sintered on WC-16 wt%Co substrate under static high pressure of 5.0 GPa at temperatures of 800 to 1 400℃for 30 min.Vickers hardness of the sinter...Cubic boron nitride(CBN) composites starting with CBN-Al mixtures were sintered on WC-16 wt%Co substrate under static high pressure of 5.0 GPa at temperatures of 800 to 1 400℃for 30 min.Vickers hardness of the sintered samples increased with increasing CBN content and the highest hardness of 32.7 GPa was achieved for the CBN-5 wt%Al specimens sintered at 1 400℃.The reactions between CBN and Al started to occur at about 900℃and the reaction products strongly depended on the Al content,sintering temperature and Co diffused from the substrates according to the x-ray diffraction(XRD) observations.The CBN composite sintered at 1 200℃from a CBN-15 wt%Al mixture showed the best cutting performance.展开更多
On the basis of reviewing the progress in the high efficient enrichment from secondary resources of low grade precious metals at home and abroad, a process route of the high efficient enrichment precious metals from s...On the basis of reviewing the progress in the high efficient enrichment from secondary resources of low grade precious metals at home and abroad, a process route of the high efficient enrichment precious metals from secondary resources of low-grade metals by adding iron oxide as the trapping agent, reducing agent, additive, mixing uniformly and grinding, pelletizing, reduction, grinding and separation, and selectively acid leaching iron has been put forward in this paper. The experiments of reduction, grinding and separation, and selectively acid leaching iron were carried out mainly. Under the decided experiment parameters and conditions, iron generated during the reduction can trap precious metals during reduction, high active alloy powders were obtained from the reduced products by grinding and separation, the concentration of precious metals was obtained by acid leaching high active alloy powders. The better enrichment effect was obtained by adopting the technical route of processing. Other low grade noble metal materials and enrichment ratio of precious metals from the materials to acid products was high through acid leaching. This process has the advantages of simple process, environmental-friendly, strong adaptability of raw materials, high concentration ratio, which was regarded as a kind of the general efficient enrichment technology of low grade precious metal materials.展开更多
随着碳捕集、利用与封存(carbon capture,utilization and storage,CCUS)技术在油田的持续应用,CO_(2)腐蚀井下管柱现象引起高度重视,亟需适用于高CO_(2)分压环境下考虑腐蚀速率随时间变化影响的腐蚀速率模型。通过模拟温度80~120℃、CO...随着碳捕集、利用与封存(carbon capture,utilization and storage,CCUS)技术在油田的持续应用,CO_(2)腐蚀井下管柱现象引起高度重视,亟需适用于高CO_(2)分压环境下考虑腐蚀速率随时间变化影响的腐蚀速率模型。通过模拟温度80~120℃、CO_(2)分压15~30 MPa条件下Q125、3Cr和13Cr管材的腐蚀,建立了这3种管材考虑温度、CO_(2)分压和腐蚀时间影响的腐蚀速率预测模型,并对Q125套管进行了安全服役寿命预测。结果表明:同一CO_(2)分压下,Q125、3Cr管材腐蚀速率随温度增加呈先增后减的趋势,13Cr管材腐蚀速率随温度增加而增大;3种管材腐蚀速率均随CO_(2)分压增加而增大。Q125管材匀速和变速两种腐蚀速率模型均适用,3Cr和13Cr管材适用变速腐蚀模型。Q125套管的抗拉安全服役年限随着CO_(2)分压的增加而逐渐降低,抗拉安全服役年限最短约为12 a。展开更多
基金Project(50574061) supported by the National Natural Science Foundation of ChinaProject(IRT0411) supported by the Changjiang Scholars and Innovative Research Team,Ministry of Education
文摘The rheological properties of two kinds of oil-based drilling fluids with typically composition were studied at pressures up to 138 MPa and temperatures up to 204 ℃ using the RheoChan 7400 Rheometer.The experimental results show that the apparent viscosity,plastic viscosity and yield point decrease with the increase of temperature,and increase with the increase of pressure.The effect of pressure on the apparent viscosity,plastic viscosity and yield point is considerable at ambient temperature.However,this effect gradually reduces with the increase of temperature.The major factor influencing the rheological properties of oil-based drilling fluids is temperature instead of pressure in the deep sections of oil wells.On the basis of numerous experiments,the model for predict the apparent viscosity,plastic viscosity and yield point of oil-based drilling fluids at high temperature and pressure was established using the method of regressive analysis.It is confirmed that the calculated data are in good agreement with the measured data,and the correlation coefficients are more than 0.98.The model is convenient for use and suitable for the application in drilling operations.
基金Supported by the National Natural Science Foundation of China(No.50342017)by the Natural Science Foundation of Beijing(No.2042019)
文摘A regrown composite fiber was synthesized during the sintering of diamond under high pressure 5.8 GPa and high temperature 1500℃for 1 min,using 3wt%MWCNTs as additive.SEM observation of the fiber after alkali and acid treatment revealed that the outer layer of the fiber is composed of nano-polycrystalline diamond.EDS,XPS,XRD and Raman spectrum analysis further identified that the fiber is composed of MWCNTs in the inner part and nano-polycrystalline diamond in the out layer.It is proposed that the untransformed MWCNTs may act as a template for the regrown outer layer of nano diamond fiber under high pressure and high temperature.
文摘Experimental and theoretical researches on the doping effect of interface binding state with homologous and heterogeneous dopants(d) in the system of PCD etc,as well as the action of intermediate layers between D /d at superhigh pressure and high temperature(HP-HT) are reported in this paper.
文摘Cubic boron nitride(CBN) composites starting with CBN-Al mixtures were sintered on WC-16 wt%Co substrate under static high pressure of 5.0 GPa at temperatures of 800 to 1 400℃for 30 min.Vickers hardness of the sintered samples increased with increasing CBN content and the highest hardness of 32.7 GPa was achieved for the CBN-5 wt%Al specimens sintered at 1 400℃.The reactions between CBN and Al started to occur at about 900℃and the reaction products strongly depended on the Al content,sintering temperature and Co diffused from the substrates according to the x-ray diffraction(XRD) observations.The CBN composite sintered at 1 200℃from a CBN-15 wt%Al mixture showed the best cutting performance.
基金The National Basic Research Program( 973 Plan) of China(2012CB724201)
文摘On the basis of reviewing the progress in the high efficient enrichment from secondary resources of low grade precious metals at home and abroad, a process route of the high efficient enrichment precious metals from secondary resources of low-grade metals by adding iron oxide as the trapping agent, reducing agent, additive, mixing uniformly and grinding, pelletizing, reduction, grinding and separation, and selectively acid leaching iron has been put forward in this paper. The experiments of reduction, grinding and separation, and selectively acid leaching iron were carried out mainly. Under the decided experiment parameters and conditions, iron generated during the reduction can trap precious metals during reduction, high active alloy powders were obtained from the reduced products by grinding and separation, the concentration of precious metals was obtained by acid leaching high active alloy powders. The better enrichment effect was obtained by adopting the technical route of processing. Other low grade noble metal materials and enrichment ratio of precious metals from the materials to acid products was high through acid leaching. This process has the advantages of simple process, environmental-friendly, strong adaptability of raw materials, high concentration ratio, which was regarded as a kind of the general efficient enrichment technology of low grade precious metal materials.
