Thermal performance is the most important factor in the development of a borehole heat exchanger utilizing geothermal energy.The thermal performance is affected by many different design parameters and different operat...Thermal performance is the most important factor in the development of a borehole heat exchanger utilizing geothermal energy.The thermal performance is affected by many different design parameters and different operating conditions such as bleeding.This eventually determines the operation and cost efficiency of the borehole heat exchanger system.The thermal performance of an open standing column well (SCW) type geothermal heat exchanger was assessed under the influence of bleeding.For this,a thermal response test rig was established with line-source theory.The test rig also had a bleeding function by releasing fluid while taking additional underground water through the heat exchanger.The thermal response test was performed with an additional constant input heat source.Effective thermal conductivity and thermal resistance were obtained from the measured data.From the measurement,the effective thermal conductivity is found to have 1.47 times higher value when bleeding is applied.The thermal resistance also increases by 1.58 times compared to a non-bleeding case.This trend indicates enhanced heat transfer in the SCW type heat exchanger with a bleeding function.Bleeding,therefore,could be an effective method of achieving a high heat transfer rate in the SCW type heat exchanger with sufficient underground water supply.展开更多
numerical simulation was conducted to study the influence of bleeding. The Euler-Lagrange method was used to investigate the two-phase turbulent combustion flow. Standard k-ε turbulent model was adopted in the contin...numerical simulation was conducted to study the influence of bleeding. The Euler-Lagrange method was used to investigate the two-phase turbulent combustion flow. Standard k-ε turbulent model was adopted in the continuous phase simulation and particle-trajectory model was adopted in the dispersed phase simulation. The results demonstrates: air bleeding can improve the flow field after the strut and the stability of trapped vortex in the cavity; change of bleeding temperature has little effect on the total pressure recovery coefficient and significant effect on combustion efficiency; When fuel-air ratio changes, the combustor performs better in a lean oil state.展开更多
Hemophilia B, affecting 1 in 30000 males, is aserious X-linked recessive bleeding disorder due to apartial or complete deficiency of human clottingfactor Ⅸ (hFⅨ) activity in the plasma. Conventionaltherapy depends o...Hemophilia B, affecting 1 in 30000 males, is aserious X-linked recessive bleeding disorder due to apartial or complete deficiency of human clottingfactor Ⅸ (hFⅨ) activity in the plasma. Conventionaltherapy depends on the infusion of human plasma orconcentrate. The therapeutic effect is temporary展开更多
The kinetics of the thermal decomposition for a naturally ageing ammonium perchlorate(AP) and hydroxyl-terminated-polybutadiene(HTPB) base bleed composite propellant were investigated using a differential scanning cal...The kinetics of the thermal decomposition for a naturally ageing ammonium perchlorate(AP) and hydroxyl-terminated-polybutadiene(HTPB) base bleed composite propellant were investigated using a differential scanning calorimetry(DSC). The naturally ageing AP/HTPB base bleed propellant samples have been stored in a sealed plastic bag at room temperature(5-25 ℃) for more than 20 years. The experimental DSC results were obtained by placing samples(each about 1.5 mg) in a sealed pan under non-isothermal condition under different heating rates, 5.0, 10.0, 15.0, 20.0 and 30.0 ℃·min^(-1). The activation energy and pre-exponential factor were estimated based on the relationship between the exothermic peak temperature and the heating rate by Ozawa and Kissinger methods, respectively. The decomposition kinetic parameters is lower the values under laboratorial aging condition.展开更多
In order to improve the benefits of base bleed in base flow field,the base flow with hot base bleed for two jet models is studied.Twodimensional axisymmetric Navier-Stokes equations are computed by using a finite volu...In order to improve the benefits of base bleed in base flow field,the base flow with hot base bleed for two jet models is studied.Twodimensional axisymmetric Navier-Stokes equations are computed by using a finite volume scheme.The base flow of a cylinder afterbody with base bleed is simulated.The simulation results are validated with the experimental data,and the experimental results are well reproduced.On this basis,the base flow fields with base bleed for a circular jet model and an annulus jet model are investigated by selecting the injection temperature from 830 K to 2200 K.The results show that the base pressure of the annular jet model is higher than that of the circular jet model with the changes of the injection parameter and the injection temperature.For the circular jet model,the hot gases are concentrated in the vicinity of the base.For the annular jet model,the bleed gases flow into the shear layer directly so that the hot gases are concentrated in the shear layer.The latter temperature distribution is better for the increase of base pressure.展开更多
基金Project supported by the Second Stage of Brain Korea 21 Projects and Changwon National University in2011-2012
文摘Thermal performance is the most important factor in the development of a borehole heat exchanger utilizing geothermal energy.The thermal performance is affected by many different design parameters and different operating conditions such as bleeding.This eventually determines the operation and cost efficiency of the borehole heat exchanger system.The thermal performance of an open standing column well (SCW) type geothermal heat exchanger was assessed under the influence of bleeding.For this,a thermal response test rig was established with line-source theory.The test rig also had a bleeding function by releasing fluid while taking additional underground water through the heat exchanger.The thermal response test was performed with an additional constant input heat source.Effective thermal conductivity and thermal resistance were obtained from the measured data.From the measurement,the effective thermal conductivity is found to have 1.47 times higher value when bleeding is applied.The thermal resistance also increases by 1.58 times compared to a non-bleeding case.This trend indicates enhanced heat transfer in the SCW type heat exchanger with a bleeding function.Bleeding,therefore,could be an effective method of achieving a high heat transfer rate in the SCW type heat exchanger with sufficient underground water supply.
文摘numerical simulation was conducted to study the influence of bleeding. The Euler-Lagrange method was used to investigate the two-phase turbulent combustion flow. Standard k-ε turbulent model was adopted in the continuous phase simulation and particle-trajectory model was adopted in the dispersed phase simulation. The results demonstrates: air bleeding can improve the flow field after the strut and the stability of trapped vortex in the cavity; change of bleeding temperature has little effect on the total pressure recovery coefficient and significant effect on combustion efficiency; When fuel-air ratio changes, the combustor performs better in a lean oil state.
文摘Hemophilia B, affecting 1 in 30000 males, is aserious X-linked recessive bleeding disorder due to apartial or complete deficiency of human clottingfactor Ⅸ (hFⅨ) activity in the plasma. Conventionaltherapy depends on the infusion of human plasma orconcentrate. The therapeutic effect is temporary
文摘The kinetics of the thermal decomposition for a naturally ageing ammonium perchlorate(AP) and hydroxyl-terminated-polybutadiene(HTPB) base bleed composite propellant were investigated using a differential scanning calorimetry(DSC). The naturally ageing AP/HTPB base bleed propellant samples have been stored in a sealed plastic bag at room temperature(5-25 ℃) for more than 20 years. The experimental DSC results were obtained by placing samples(each about 1.5 mg) in a sealed pan under non-isothermal condition under different heating rates, 5.0, 10.0, 15.0, 20.0 and 30.0 ℃·min^(-1). The activation energy and pre-exponential factor were estimated based on the relationship between the exothermic peak temperature and the heating rate by Ozawa and Kissinger methods, respectively. The decomposition kinetic parameters is lower the values under laboratorial aging condition.
基金supported by National Nature Science Foundation of China(Grant No.51176076)
文摘In order to improve the benefits of base bleed in base flow field,the base flow with hot base bleed for two jet models is studied.Twodimensional axisymmetric Navier-Stokes equations are computed by using a finite volume scheme.The base flow of a cylinder afterbody with base bleed is simulated.The simulation results are validated with the experimental data,and the experimental results are well reproduced.On this basis,the base flow fields with base bleed for a circular jet model and an annulus jet model are investigated by selecting the injection temperature from 830 K to 2200 K.The results show that the base pressure of the annular jet model is higher than that of the circular jet model with the changes of the injection parameter and the injection temperature.For the circular jet model,the hot gases are concentrated in the vicinity of the base.For the annular jet model,the bleed gases flow into the shear layer directly so that the hot gases are concentrated in the shear layer.The latter temperature distribution is better for the increase of base pressure.
