期刊文献+
共找到2篇文章
< 1 >
每页显示 20 50 100
分度圆裂纹齿轮啮合刚度计算及啮合动态特性分析 被引量:3
1
作者 徐凤宝 刘贵杰 +2 位作者 马鹏磊 王泓晖 陈帅 《机电工程》 CAS 北大核心 2022年第12期1714-1719,共6页
为了探究分度圆裂纹对齿轮传动系统产生的影响,利用改进能量法计算分度圆裂纹齿轮的啮合刚度,结合动力学模型对齿轮传动系统进行了动态特性分析。首先,将齿轮的齿根圆视为悬臂梁起点,把分度圆裂纹按照其齿廓投影位置分为了3种情况;然后... 为了探究分度圆裂纹对齿轮传动系统产生的影响,利用改进能量法计算分度圆裂纹齿轮的啮合刚度,结合动力学模型对齿轮传动系统进行了动态特性分析。首先,将齿轮的齿根圆视为悬臂梁起点,把分度圆裂纹按照其齿廓投影位置分为了3种情况;然后,利用改进能量法理论计算了不同裂纹情况下的齿轮啮合刚度;最后,在啮合刚度的基础上,建立了齿轮系统的六自由度动力学模型,分析了不同裂纹情况下的齿轮系统的动态特性。仿真结果表明:相比于正常齿轮,分度圆裂纹为2.5 mm时,齿轮的啮合刚度最多下降14.3%,传递误差最多升高12.2%,齿间啮合力最多下降3.6%,啮合摩擦力最多下降14.8%;随着裂纹长度增大,齿轮啮合刚度逐渐降低,传递误差随之增大,齿间啮合力和啮合摩擦力逐渐降低。研究结果表明:由于裂纹的影响,齿轮传动系统会受到周期性冲击。 展开更多
关键词 齿轮传动系统振动 传递误差 齿间啮合力 改进能量法 动力学模型 啮合摩擦力 齿轮点蚀、剥落 时域图、频谱图
在线阅读 下载PDF
Super-harmonic resonance of gear transmission system under stick-slip vibration in high-speed train 被引量:6
2
作者 HUANG Guan-hua XU Si-si +1 位作者 ZHANG Wei-hua YANG Cai-jin 《Journal of Central South University》 SCIE EI CAS CSCD 2017年第3期726-735,共10页
This work deals with super-harmonic responses and the stabilities of a gear transmission system of a high-speed train under the stick-slip oscillation of the wheel-set.The dynamic model of the system is developed with... This work deals with super-harmonic responses and the stabilities of a gear transmission system of a high-speed train under the stick-slip oscillation of the wheel-set.The dynamic model of the system is developed with consideration on the factors including the time-varying system stiffness,the transmission error,the tooth backlash and the self-excited excitation of the wheel-set.The frequency-response equation of the system at super-harmonic resonance is obtained by the multiple scales method,and the stabilities of the system are analyzed using the perturbation theory.Complex nonlinear behaviors of the system including multi-valued solutions,jump phenomenon,hardening stiffness are found.The effects of the equivalent damping and the loads of the system under the stick-slip oscillation are analyzed.It shows that the change of the load can obviously influence the resonance frequency of the system and have little effect on the steady-state response amplitude of the system.The damping of the system has a negative effect,opposite to the load.The synthetic damping of the system composed of meshing damping and equivalent damping may be less than zero when the wheel-set has a large slippage,and the system loses its stability owing to the Hopf bifurcation.Analytical results are validated by numerical simulations. 展开更多
关键词 stick-slip vibration super-harmonic resonance Hopf bifurcation gear transmission system high-speed train
在线阅读 下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部