The Al-Cu wheel adopting the new Al alloy was prepared by the liquid-die forging,and the mechanical properties,composition distribution,microstructure and fracture behavior were investigated.The results showed that se...The Al-Cu wheel adopting the new Al alloy was prepared by the liquid-die forging,and the mechanical properties,composition distribution,microstructure and fracture behavior were investigated.The results showed that serious Cu segregation was found in the wheel specimen;the microstructure of the Al-Cu wheel was comprised of the casting microstructure and a small amount of the deformed microstructure;the best heat treatment and water quenching system were found to solution treated at(530±5)℃ for 4 h followed by(535±5)℃ for 24 h and aging treated at(155±5)℃ for 4 h;the fracture morphologies of the samples heated under T 6 and T 5-1 heat treatment showed flat,tough nest,and poor plastic characteristics;the fracture morphologies of the samples heated under T 4 heat treatment exhibited complete resilience,but no residual metallographic characteristic;the sample treated under T 4 protocol had the best elongation;the fracture failure was mainly due to the formation of the CuAl_(2)(θ)phases;and the fracture mechanism of the Al-Cu wheel was intergranular fracture.展开更多
Ni Fe2O4 ceramics were prepared in different sintering atmospheres. The phase compositions, microstructures and mechanical properties were studied. The results show that the stoichiometric compound Ni Fe2O4 cannot be ...Ni Fe2O4 ceramics were prepared in different sintering atmospheres. The phase compositions, microstructures and mechanical properties were studied. The results show that the stoichiometric compound Ni Fe2O4 cannot be obtained in vacuum or atmospheres with oxygen contents of 2×10-5, 2×10-4 and 2×10-3, respectively. All the samples sintered in above-mentioned atmospheres contain phases of Ni Fe2O4 and Ni O. With increasing oxygen content, Ni Fe2O4 content in the ceramic increases, while Ni O content appears a contrary trend. In vacuum, Ni Fe2O4 ceramic has average grain size of 3.94 μm, and bending strength of85.12 MPa. The changes of the phase composition and mechanical properties of Ni Fe2O4 based cermets are mainly caused by the alteration of their properties of Ni Fe2O4 ceramic.展开更多
The effect of temperature in range of 155-175 ℃ on the creep behavior, microstructural evolution, and precipitation of an Al-Cu-Li alloy was experimentally investigated during creep ageing deformation under 180 MPa f...The effect of temperature in range of 155-175 ℃ on the creep behavior, microstructural evolution, and precipitation of an Al-Cu-Li alloy was experimentally investigated during creep ageing deformation under 180 MPa for 20 h. Increasing temperature resulted in a noteworthy change in creep ageing behaviour, including a variation in creep curves, an improvement in creep rate during early creep ageing, and an increased creep strain. Tensile tests indicate that the specimen aged at higher temperature reached peak strength within a shorter time. Transmission electron microscopy(TEM) was employed to explore the effect of temperature on the microstructural evolution of the AA2198 during creep ageing deformation. Many larger dislocations and even tangled dislocation structures were observed in the sample aged at higher temperature. The number of T1 precipitates increased at higher ageing temperature at the same ageing time. Based on the analysed results, a new mechanism, considering the combined effects of the formation of larger dislocation structures induced by higher temperature and diffusion of solute atoms towards these larger or tangled dislocations, was proposed to explain the effect of temperature on microstructural evolution and creep behaviour.展开更多
The impact of extreme temperatures on the health of individuals in different organizations remains uncertain.We employed stratified analyses to examine the impacts of summer(April-September)daily maximum temperatures ...The impact of extreme temperatures on the health of individuals in different organizations remains uncertain.We employed stratified analyses to examine the impacts of summer(April-September)daily maximum temperatures and winter(October-March)daily minimum temperatures on blood pressure and lipid profiles across government staff,com-pany employees,and researchers.We examined 209,477 physical examination records from a physical examination center in the First Affiliated Hospital of USTC from 2017 to 2021.Employing a segmented regression model within the frame-work of generalized linear regression(GLM),we examined the causal impact of extreme temperatures on health outcomes.Additionally,sensitivity analyses were conducted via distributed lag nonlinear models(DLNMs),with a focus on ob-serving the long-term effects over a period of 21 days.Our findings indicate that government staff face increased health risks during extremely low temperatures,regardless of the season.Compared with participants experiencing median tem-peratures,government staff exposed to extremely low temperatures(below the 10th percentile,below 24℃)in the sum-mer presented maximum increases of 2.32 mmHg(95%CI:1.542-3.098)in diastolic blood pressure and 6.481 mmHg(95%CI:5.368-7.594)in systolic blood pressure.In winter,government staff exposed to temperatures below the 10th per-centile(below 1℃)demonstrated maximum increases of 0.278 mmol/L(95%CI:0.210-0.346)in total cholesterol,0.153 mmol/L(95%CI:0.032-0.274)in triglycerides,and 0.077 mmol/L(95%CI:0.192-0.134)in low-density lipoprotein.Conversely,warm winters benefit company employees,whereas researchers exhibit lower sensitivity to temperature changes in winter.The maximum temperatures in summer and minimum temperatures in winter had greater impacts on in-dividuals.Small temperature fluctuations impact health more than large changes do.Notably,both the maximum and min-imum temperatures were better predictors of health outcomes than the daily average temperature was.Blood pressure con-sistently displayed significant associations with temperature across all three groups,with extremely low temperatures in-creasing the risk and extremely high temperatures reducing it.However,the relationship between temperature and blood lipids is complex.展开更多
基金Project(2019 YFC 1511400)supported by the National Key Technologies R&D Program of China。
文摘The Al-Cu wheel adopting the new Al alloy was prepared by the liquid-die forging,and the mechanical properties,composition distribution,microstructure and fracture behavior were investigated.The results showed that serious Cu segregation was found in the wheel specimen;the microstructure of the Al-Cu wheel was comprised of the casting microstructure and a small amount of the deformed microstructure;the best heat treatment and water quenching system were found to solution treated at(530±5)℃ for 4 h followed by(535±5)℃ for 24 h and aging treated at(155±5)℃ for 4 h;the fracture morphologies of the samples heated under T 6 and T 5-1 heat treatment showed flat,tough nest,and poor plastic characteristics;the fracture morphologies of the samples heated under T 4 heat treatment exhibited complete resilience,but no residual metallographic characteristic;the sample treated under T 4 protocol had the best elongation;the fracture failure was mainly due to the formation of the CuAl_(2)(θ)phases;and the fracture mechanism of the Al-Cu wheel was intergranular fracture.
基金Project(2008AA030503)supported by the National High Technology Research and Development Program of ChinaProject(51474238)supported by the National Natural Science Foundation of China
文摘Ni Fe2O4 ceramics were prepared in different sintering atmospheres. The phase compositions, microstructures and mechanical properties were studied. The results show that the stoichiometric compound Ni Fe2O4 cannot be obtained in vacuum or atmospheres with oxygen contents of 2×10-5, 2×10-4 and 2×10-3, respectively. All the samples sintered in above-mentioned atmospheres contain phases of Ni Fe2O4 and Ni O. With increasing oxygen content, Ni Fe2O4 content in the ceramic increases, while Ni O content appears a contrary trend. In vacuum, Ni Fe2O4 ceramic has average grain size of 3.94 μm, and bending strength of85.12 MPa. The changes of the phase composition and mechanical properties of Ni Fe2O4 based cermets are mainly caused by the alteration of their properties of Ni Fe2O4 ceramic.
基金Project(2017YFB0306300)supported by the National Key R&D Program of ChinaProjects(51601060,51675538)supported by the National Natural Science Foundation of China。
文摘The effect of temperature in range of 155-175 ℃ on the creep behavior, microstructural evolution, and precipitation of an Al-Cu-Li alloy was experimentally investigated during creep ageing deformation under 180 MPa for 20 h. Increasing temperature resulted in a noteworthy change in creep ageing behaviour, including a variation in creep curves, an improvement in creep rate during early creep ageing, and an increased creep strain. Tensile tests indicate that the specimen aged at higher temperature reached peak strength within a shorter time. Transmission electron microscopy(TEM) was employed to explore the effect of temperature on the microstructural evolution of the AA2198 during creep ageing deformation. Many larger dislocations and even tangled dislocation structures were observed in the sample aged at higher temperature. The number of T1 precipitates increased at higher ageing temperature at the same ageing time. Based on the analysed results, a new mechanism, considering the combined effects of the formation of larger dislocation structures induced by higher temperature and diffusion of solute atoms towards these larger or tangled dislocations, was proposed to explain the effect of temperature on microstructural evolution and creep behaviour.
基金supported by the National Natural Science Foundation of China(72072169)the Fundamental Re-search Funds for the Central Universities(YD2040002015).
文摘The impact of extreme temperatures on the health of individuals in different organizations remains uncertain.We employed stratified analyses to examine the impacts of summer(April-September)daily maximum temperatures and winter(October-March)daily minimum temperatures on blood pressure and lipid profiles across government staff,com-pany employees,and researchers.We examined 209,477 physical examination records from a physical examination center in the First Affiliated Hospital of USTC from 2017 to 2021.Employing a segmented regression model within the frame-work of generalized linear regression(GLM),we examined the causal impact of extreme temperatures on health outcomes.Additionally,sensitivity analyses were conducted via distributed lag nonlinear models(DLNMs),with a focus on ob-serving the long-term effects over a period of 21 days.Our findings indicate that government staff face increased health risks during extremely low temperatures,regardless of the season.Compared with participants experiencing median tem-peratures,government staff exposed to extremely low temperatures(below the 10th percentile,below 24℃)in the sum-mer presented maximum increases of 2.32 mmHg(95%CI:1.542-3.098)in diastolic blood pressure and 6.481 mmHg(95%CI:5.368-7.594)in systolic blood pressure.In winter,government staff exposed to temperatures below the 10th per-centile(below 1℃)demonstrated maximum increases of 0.278 mmol/L(95%CI:0.210-0.346)in total cholesterol,0.153 mmol/L(95%CI:0.032-0.274)in triglycerides,and 0.077 mmol/L(95%CI:0.192-0.134)in low-density lipoprotein.Conversely,warm winters benefit company employees,whereas researchers exhibit lower sensitivity to temperature changes in winter.The maximum temperatures in summer and minimum temperatures in winter had greater impacts on in-dividuals.Small temperature fluctuations impact health more than large changes do.Notably,both the maximum and min-imum temperatures were better predictors of health outcomes than the daily average temperature was.Blood pressure con-sistently displayed significant associations with temperature across all three groups,with extremely low temperatures in-creasing the risk and extremely high temperatures reducing it.However,the relationship between temperature and blood lipids is complex.
