A high precision, high antijamming multipoint infrared telemetry system was developed to measure the piston temperature in internal combustion engine. The temperature at the measuring point is converted into correspon...A high precision, high antijamming multipoint infrared telemetry system was developed to measure the piston temperature in internal combustion engine. The temperature at the measuring point is converted into corresponding voltage signal by the thermo-couple first. Then after the V/F stage, the voltage signal is converted into the frequency signal to drive the infrared light-emitting diode to transmit infrared pulses. At the receiver end, a photosensitive audion receives the infrared pulses. After conversion, the voltage recorded by the receiver stands for the magnitude of temperature at the measuring point. Test results of the system indicate that the system is practical and the system can perform multipoint looping temperature measurements for the piston.展开更多
This paper lenges in the design of discusses some chal- millimeter-wave （mln- wave） circuits and systems for 5th generation （5G） wireless systems in CMOS process. The properties of some passive and active devices ...This paper lenges in the design of discusses some chal- millimeter-wave （mln- wave） circuits and systems for 5th generation （5G） wireless systems in CMOS process. The properties of some passive and active devices such as inductors, capacitors, transmission lines, translbrmers and transistors in mm-wave frequency band are discussed. Self-healing technique dealing with PVT variation, res- onant mode switching technique to enhance frequency tuning range of voltage controlled oscillator （VCO） and dual mode technique for power amplifier （PA） efficiency enhancement are introduced. At last, A fully-integrated 60 GHz 5 Gb/s QPSK transceiver with the transmit/receive （T/R） switch in 65nm CMOS process is introduced. The measured error vector magnitude （EVM） of the TX is -21.9 dB while the bit error rate （BER） of the RX with a -52 dBm sine-wave input is below 8e-7 when transmitting/receiving 5 Gb/s data. The transceiver is powered by 1.0 V and 1.2 V supply （except the phase-frequency detector and charge-pump in the frequency synthesizer which are powered by 2.5 V supply） and con- sumes 135 mW in TX mode and 176 mW in RX mode.展开更多
Based on the characteristic of AC-excited variable speed constant frequency(VSCF)wind power generation,the vector control technique was applied in a doubly fed induction generator(DFIG).Maximum wind energy or maximum ...Based on the characteristic of AC-excited variable speed constant frequency(VSCF)wind power generation,the vector control technique was applied in a doubly fed induction generator(DFIG).Maximum wind energy or maximum output power point can be tracked by decoupling control of active power and reactive power.The research result shows that the net power of generation system delivered to grid in maximum wind energy tracking mode is not the most.We presented a novel maximum power point tracking(MPPT)control strategy by analyzing the DFIG mathematic model and power relations which delivered the maximum power to the grid.The maximum power point could be tracked automatically without measuring wind speed in the control strategy and the control was independent of optimal turbine power curve,which had excellent dynamic and static performances and robustness.Simulation and experimental results testify the accuracy and validity of the control strategy.展开更多
文摘A high precision, high antijamming multipoint infrared telemetry system was developed to measure the piston temperature in internal combustion engine. The temperature at the measuring point is converted into corresponding voltage signal by the thermo-couple first. Then after the V/F stage, the voltage signal is converted into the frequency signal to drive the infrared light-emitting diode to transmit infrared pulses. At the receiver end, a photosensitive audion receives the infrared pulses. After conversion, the voltage recorded by the receiver stands for the magnitude of temperature at the measuring point. Test results of the system indicate that the system is practical and the system can perform multipoint looping temperature measurements for the piston.
基金supported in part by the National Natural Science Foundation of China under Grant 61331003 and Grant 61222405
文摘This paper lenges in the design of discusses some chal- millimeter-wave （mln- wave） circuits and systems for 5th generation （5G） wireless systems in CMOS process. The properties of some passive and active devices such as inductors, capacitors, transmission lines, translbrmers and transistors in mm-wave frequency band are discussed. Self-healing technique dealing with PVT variation, res- onant mode switching technique to enhance frequency tuning range of voltage controlled oscillator （VCO） and dual mode technique for power amplifier （PA） efficiency enhancement are introduced. At last, A fully-integrated 60 GHz 5 Gb/s QPSK transceiver with the transmit/receive （T/R） switch in 65nm CMOS process is introduced. The measured error vector magnitude （EVM） of the TX is -21.9 dB while the bit error rate （BER） of the RX with a -52 dBm sine-wave input is below 8e-7 when transmitting/receiving 5 Gb/s data. The transceiver is powered by 1.0 V and 1.2 V supply （except the phase-frequency detector and charge-pump in the frequency synthesizer which are powered by 2.5 V supply） and con- sumes 135 mW in TX mode and 176 mW in RX mode.
基金Funded by the National Natural Science Foundation of China(No.60974049)the Science and Technology Support Industrial Project of Jiangsu Province(No.BZ2008031,No.BE2008074,and No.BE2009090)+1 种基金the Nantong International Cooperative Project(No.W2009003)the Natural Science Foundation of Nantong University(No.08Z022 and No.08Z025).
文摘Based on the characteristic of AC-excited variable speed constant frequency(VSCF)wind power generation,the vector control technique was applied in a doubly fed induction generator(DFIG).Maximum wind energy or maximum output power point can be tracked by decoupling control of active power and reactive power.The research result shows that the net power of generation system delivered to grid in maximum wind energy tracking mode is not the most.We presented a novel maximum power point tracking(MPPT)control strategy by analyzing the DFIG mathematic model and power relations which delivered the maximum power to the grid.The maximum power point could be tracked automatically without measuring wind speed in the control strategy and the control was independent of optimal turbine power curve,which had excellent dynamic and static performances and robustness.Simulation and experimental results testify the accuracy and validity of the control strategy.
