期刊文献+
共找到8篇文章
< 1 >
每页显示 20 50 100
我国部分矿区煤的水润湿性研究 被引量:7
1
作者 傅贵 秦凤华 阎保金 《阜新矿业学院学报》 1997年第6期666-669,共4页
用快速照相法研究了我国部分矿区煤的水润湿性及其变化规律.研究证实,煤的水润湿性与煤的工业分析指标间没有明显的相关关系,而与煤的显微组分及有机质元素组成却有明显的规律性联系,煤中镜质组分含量越高,氧元素含量越高,其水润湿性越... 用快速照相法研究了我国部分矿区煤的水润湿性及其变化规律.研究证实,煤的水润湿性与煤的工业分析指标间没有明显的相关关系,而与煤的显微组分及有机质元素组成却有明显的规律性联系,煤中镜质组分含量越高,氧元素含量越高,其水润湿性越好,水力防尘效果也越好. 展开更多
关键词 煤矿 水润湿性 工业分析 元素组成 力防尘
在线阅读 下载PDF
水热法制备氢氧化镁改性鳞片石墨
2
作者 周瑞琪 范慧琳 +3 位作者 王智明 蔡伟杰 段红娟 张海军 《耐火材料》 CAS 北大核心 2023年第2期117-120,共4页
为了提高鳞片石墨的水润湿性,以无水硫酸镁和氨水为主要原料,采用水热法在鳞片石墨表面生成氢氧化镁改性层,主要研究了表面活性剂种类(十二烷基苯磺酸钠、聚丙烯酸钠),水热温度(180、190、200℃),C、Mg^(2+)质量比(1∶10、2∶10、3∶10... 为了提高鳞片石墨的水润湿性,以无水硫酸镁和氨水为主要原料,采用水热法在鳞片石墨表面生成氢氧化镁改性层,主要研究了表面活性剂种类(十二烷基苯磺酸钠、聚丙烯酸钠),水热温度(180、190、200℃),C、Mg^(2+)质量比(1∶10、2∶10、3∶10)对改性鳞片石墨水润湿性和抗氧化性的影响。结果表明:1)改性石墨表面生成了片状氢氧化镁包覆层,其水润湿性和抗氧化性提高。2)以聚丙烯酸钠为表面活性剂,采用3∶10的C、Mg^(2+)质量比,在190℃水热处理12 h,制得的改性石墨的水润湿性和抗氧化性最好。 展开更多
关键词 鳞片石墨 热法 表面改性 水润湿性 抗氧化性
在线阅读 下载PDF
含碳浇注料用鳞片石墨的表面改性技术综述 被引量:5
3
作者 毕玉保 王慧芳 +2 位作者 赵万国 梁峰 张海军 《材料导报》 EI CAS CSCD 北大核心 2017年第15期108-114,共7页
不定形耐火材料由于具有施工方便、整体性好及无需高温烧成等一系列优点而得到广泛应用,鳞片石墨的引入可显著提高耐火材料的热震稳定性和抗渣侵蚀性,但鳞片石墨较差的水润湿性与分散性使其难以直接在浇注料中加以应用,限制了含碳浇注... 不定形耐火材料由于具有施工方便、整体性好及无需高温烧成等一系列优点而得到广泛应用,鳞片石墨的引入可显著提高耐火材料的热震稳定性和抗渣侵蚀性,但鳞片石墨较差的水润湿性与分散性使其难以直接在浇注料中加以应用,限制了含碳浇注料的发展。石墨表面改性是解决上述问题的有效途径。文章综述了近年来石墨表面改性的研究进展,包括采用溶胶-凝胶法在石墨表面形成二元氧化物(如Al_2O_3、SiO_2、TiO_2及ZrO_2)涂层或三元复合氧化物(如MgAl_2O_4、莫来石及铝酸钙等)涂层,通过高温原位反应在石墨表面形成碳化物(如SiC及TiC等)涂层,以及采用合适的表面活性剂来改善鳞片石墨的水润湿性等。分析了表面改性石墨在含碳浇注料中的应用研究状况,对鳞片石墨的表面改性方法、改性层的形成机理及影响因素进行了简要总结,最后从改善表面涂层与石墨基体间的结合方式、降低能耗的先进加热方式及选取高效的表面活性剂等方面对含碳浇注料的未来发展作了展望。 展开更多
关键词 鳞片石墨 表面改性 水润湿性 含碳浇注料
在线阅读 下载PDF
微波熔盐法制备SiC改性石墨 被引量:8
4
作者 毕玉保 王慧芳 +2 位作者 王铭 张海军 张少伟 《耐火材料》 北大核心 2017年第6期418-421,共4页
为了改善石墨的水润湿性,使其在浇注料中易分散,以鳞片石墨和硅粉为原料,以NaCl-NaF为复合熔盐介质,采用微波熔盐法在石墨表面原位生成SiC涂层对其进行改性,并研究了反应温度(分别为1 100、1 150与1 200℃,均保温2 h)、石墨与硅粉的比例... 为了改善石墨的水润湿性,使其在浇注料中易分散,以鳞片石墨和硅粉为原料,以NaCl-NaF为复合熔盐介质,采用微波熔盐法在石墨表面原位生成SiC涂层对其进行改性,并研究了反应温度(分别为1 100、1 150与1 200℃,均保温2 h)、石墨与硅粉的比例(n(C)n(Si)分别为1、3和5)以及复合熔盐与反应物料的比例(m盐m料分别为1、2和3)对SiC改性石墨润湿性的影响。结果表明:1)采用微波熔盐法,在1 150℃的较低温度下就可以在石墨表面形成均匀的SiC涂层,而经SiC改性后的石墨,其水润湿性得到了明显改善;2)在本试验条件下,当鳞片石墨与Si粉的比例为n(C)n(Si)=3,m盐m料=2,反应温度为1 200℃时,得到的改性石墨性能较好。 展开更多
关键词 改性石墨 SIC涂层 微波熔盐法 水润湿性
在线阅读 下载PDF
对石墨表面进行预氧化处理以改善纳米镁铝尖晶石对其表面的包覆效果
5
作者 张艳利 《耐火材料》 CAS 北大核心 2009年第6期416-416,共1页
关键词 预氧化处理 石墨表面 镁铝尖晶石 纳米尖晶石 包覆效果 水润湿性 研究人员 表面包覆
在线阅读 下载PDF
Femtosecond laser micro/nano fabrication for bioinspired superhydrophobic or underwater superoleophobic surfaces 被引量:11
6
作者 ZHU Zhuo WU Jun-rui +3 位作者 WU Zhi-peng WU Ting-ni HE Yu-chun YIN Kai 《Journal of Central South University》 SCIE EI CAS CSCD 2021年第12期3882-3906,共25页
The preparation of superhydrophobic or underwater superoleophobic interface materials has become a research hotspot because of their wide application in self-cleaning, drag reduction, oil-water separation, anti-oil po... The preparation of superhydrophobic or underwater superoleophobic interface materials has become a research hotspot because of their wide application in self-cleaning, drag reduction, oil-water separation, anti-oil pollution and so on. The unique wettability of organisms gives inspiration to design and create new interface materials. This review focuses on the recent research progress of femtosecond laser micro/nano fabrication for bioinspired superhydrophobic or underwater superoleophobic surfaces. This review starts with a presentation of the related background including the advantages of femtosecond laser and wettability theoretical basis. Then, organisms with unique wettability in nature, the preparation of superhydrophobic or underwater superoleophobic surfaces by femtosecond lasers on different materials, and their related important applications are introduced. Finally, the current challenges and future prospects with regard to this field are provided. 展开更多
关键词 femtosecond laser SUPERHYDROPHOBIC underwater superoleophobic BIOINSPIRED WETTABILITY
在线阅读 下载PDF
Transition of super-hydrophobic states of droplet on rough surface 被引量:2
7
作者 叶霞 周明 +2 位作者 蒋大林 李健 蔡兰 《Journal of Central South University》 SCIE EI CAS 2010年第3期554-559,共6页
Twelve samples with periodic array square pillars microstructure were prepared on the silicon wafer by plasma etching techniques, on which space b of the square pillars increased from 5 to 60 μm. In order to study th... Twelve samples with periodic array square pillars microstructure were prepared on the silicon wafer by plasma etching techniques, on which space b of the square pillars increased from 5 to 60 μm. In order to study the effect ofb on the wettability of the rough surface, the effects of apparent contact angle (CA) and sliding angle (a) of the droplet on the rough surface were measured with the contact angle meter. The results show that the experimental values of CA well agree with the classical wetting theory and a decreases with the increase of b. Two drop shapes exist on the samples' surface, corresponding to the Cassie state and the Wenzel state respectively. The contact state in which a drop would settle depends typically on the size of b. On the role of gravitation, the irreversible transition of a drop from Cassie state to Wenzel state should occur at a certain space of the square pillars. Since the transition has implications on the application of super-hydrophobic rough surfaces, theoretically, the prediction of wetting state transition on square pillar array micro-structured surfaces provides an intuitionistic guidance for the design of steady superhydrophobic surfaces. 展开更多
关键词 square pillar microstructure wetting mode transition apparent contact angle sliding angle
在线阅读 下载PDF
Displacement behavior and mechanism of long-term water flooding in sandstone oil reservoirs 被引量:2
8
作者 CAO Ren-yi DAI Zong +4 位作者 WANG Zhi-kai WANG Ya-hui JIANG Jun LI hai-long JIA Zhi-hao 《Journal of Central South University》 SCIE EI CAS CSCD 2021年第3期834-847,共14页
Sandstone oil reservoirs with huge bottom water and high permeability are generally developed with high flow rate.After long-term water flooding(LTWF),the water flooding characteristics are quite different from that o... Sandstone oil reservoirs with huge bottom water and high permeability are generally developed with high flow rate.After long-term water flooding(LTWF),the water flooding characteristics are quite different from that of original reservoir.In this paper,the effects of the PV number,viscosity,and displacement rate during LTWF are studied through experiments.The mechanism is analyzed based on analysis of changes in oil composition,rock mineral composition and wettability.The oil-water relative permeability curves,oil recovery and wettability were obtained with new experiments methods,which avoids the oil metering error by measuring oil and water separately.The research indicates that when the viscosity increases,the water phase permeability decreases,the residual oil saturation increases,and the water content rate increases earlier.A higher water flooding rate results in a higher ultimate recovery.A higher asphaltene content results in a higher viscosity and more oil-wet reservoir conditions.After LTWF,the wettability tends to water-wet,which is more favorable for heavy oil recovery.Moreover,LTWF reduces the clay content,which creates a more water-wet surface and a larger reservoir pore throat environment.This research provides insightful characteristics of offshore sandstone oil reservoirs,which can be used to enhance oil recovery. 展开更多
关键词 long-term water flooding sandstone reservoir relative permeability curve WETTABILITY
在线阅读 下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部