期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
基于水动力数值计算的小流域设计洪水模拟研究
1
作者 王盼 程龙 +2 位作者 蒲博文 郭上渲 歧雅菲 《水电与抽水蓄能》 2024年第4期14-19,共6页
基于水动力数值模拟方法,选择广州市花都区新街河流域作为研究区域,设计洪水计算分为天然和城市两类下垫面来考虑。采用MIKE11构建一维河道水动力模型,MIKE Urban构建管网水流模型,MIKE FLOOD耦合一维水动力模型与管网水流模型,推求新... 基于水动力数值模拟方法,选择广州市花都区新街河流域作为研究区域,设计洪水计算分为天然和城市两类下垫面来考虑。采用MIKE11构建一维河道水动力模型,MIKE Urban构建管网水流模型,MIKE FLOOD耦合一维水动力模型与管网水流模型,推求新街河流域不同河道断面处的典型频率设计洪水。将耦合模型计算的设计洪水成果与传统水文分析方法计算的设计洪水成果进行对比,分析考虑了城市管网后流域洪水计算发生的变化;根据研究结果,对比综合单位线法和城市洪水耦合模型两种方法的计算结果,整体来说耦合模型计算的设计洪水成果偏大,符合一般地区城市化后洪水过程洪峰增大的变化规律;部分河涌耦合模型的设计洪水成果偏小,与径流在复杂的城市管网中的流动滞时、管径过流能力不足等原因有关。 展开更多
关键词 水动力数值计算 MIKE 耦合模型 城市设计洪
在线阅读 下载PDF
椭球体定常流动粘性流场和水动力计算方法研究 被引量:2
2
作者 于向阳 姚凌虹 +2 位作者 孟庆昌 刘巨斌 张志宏 《舰船电子工程》 2019年第7期187-193,共7页
潜艇等水下航行体粘性流场和水动力对其操纵性预报至关重要。而潜艇等水下航行体作操纵运动时,其水动力主要集中在主体部分,因此主体水动力预报的准确程度备受关注。6:1椭球体类似于潜艇等水下航行体的主体,对其流动预报的结果可以间接... 潜艇等水下航行体粘性流场和水动力对其操纵性预报至关重要。而潜艇等水下航行体作操纵运动时,其水动力主要集中在主体部分,因此主体水动力预报的准确程度备受关注。6:1椭球体类似于潜艇等水下航行体的主体,对其流动预报的结果可以间接检验数值计算模型对潜艇等水下航行体操纵性预报的能力。论文应用CFD软件对6:1椭球体水动力进行数值模拟。采用基于非结构化网格的有限体积法离散控制方程和湍流模式,对流项采用二阶迎风格式,速度-压力耦合采用SIMPLE方法处理,得到6个攻角的水动力数值计算结果。综合比较5种湍流模型对椭球体的水动力数值计算结果,并且分析了不同计算域,不同网格密度等对数值计算结果的影响。结果表明:SA和SST模型具有较好的计算效果,并且认为以牺牲1.5%网格密度相对偏差换取百万网格的代价值得考虑。论文的计算结果和结论为后续湍流模式、计算域范围和网格密度的研究提供了参考依据。 展开更多
关键词 椭球体 定常流动粘性流场计算 水动力数值计算
在线阅读 下载PDF
波浪作用下半潜式网箱浮架结构的参数敏感性分析
3
作者 孔令蔚 杨蕖 +1 位作者 马超 赵云鹏 《渔业现代化》 CSCD 北大核心 2024年第3期33-45,共13页
为了探究半潜式网箱在波浪作用下的力学性能,针对该网箱构件的外径进行参数敏感性分析,采用边界元方法建立了一种半潜式网箱的水动力数值计算模型,在验证模型准确性后,引入有限元方法计算了网箱的应力分布。随后基于拉丁超立方抽样法抽... 为了探究半潜式网箱在波浪作用下的力学性能,针对该网箱构件的外径进行参数敏感性分析,采用边界元方法建立了一种半潜式网箱的水动力数值计算模型,在验证模型准确性后,引入有限元方法计算了网箱的应力分布。随后基于拉丁超立方抽样法抽取样本方案并计算了各个设计参数的Spearman系数,依据该系数对各设计参数的敏感性进行了整体分析。随后进一步单独分析了参数的敏感性,给出了这些参数在结构优化时的推荐取值范围。结果显示,半潜式网箱的各设计参数在其取值范围内与网箱最大应力呈负相关关系。其中:下支撑管外径的敏感性最高,而其他参数的敏感性较接近。上弧管和下弧管外径推荐的取值范围较大,分别为36~56 cm和46~76 cm;中弧管、斜管和细立柱外径推荐的取值范围较小,分别为23~28 cm、38~40 cm和50~60 cm;下支撑管和上支撑管外径的取值不得低于70 cm和50 cm。研究结果可为半潜式网箱在波浪作用下的结构优化提供参考。 展开更多
关键词 半潜式网箱 参数敏感性 结构强度分析 水动力数值计算
在线阅读 下载PDF
Numerical simulation of bubble chaotic motion in a cavitating water jet 被引量:5
4
作者 卢义玉 《Journal of Chongqing University》 CAS 2003年第1期91-94,共4页
A computational fluid dynamics (CFD) method is developed to investigate the radical motion of single cavitating bubble in the oscillating pressure field of a cavitating water jet. Regarding water as a compressible flu... A computational fluid dynamics (CFD) method is developed to investigate the radical motion of single cavitating bubble in the oscillating pressure field of a cavitating water jet. Regarding water as a compressible fluid, the simulation is performed at different oscillating frequencies. It is found that the bubble motion presents obvious nonlinear feature, and bifurcation and chaos appear on some conditions. The results manifest the indetermination of the cavitating bubble motion in the oscillating pressure field of the cavitating water jet. 展开更多
关键词 cavitating water jet cavitating bubble motion numerical simulation
在线阅读 下载PDF
Comparative Analysis of the Separation Variation Influence on the Hydrodynamic Performance of a High Speed Trimaran 被引量:1
5
作者 Khaled Hafez Abdel-Rahman El-Kot 《Journal of Marine Science and Application》 2011年第4期377-393,共17页
This paper numerically investigates the influence of separation variation of the outriggers on the hydrodynamic performance of a high speed trimaran (HST) aiming at improving its applicability in diverse realistic d... This paper numerically investigates the influence of separation variation of the outriggers on the hydrodynamic performance of a high speed trimaran (HST) aiming at improving its applicability in diverse realistic disciplines. The present investigation was performed within the framework of the 2-D slender body method (SBM) by calculating the resistance of three symmetric trimaran series moving in a calm free surface of deep water. Each trimaran series comprises of 4681 configurations generated by considering 151 staggers (-50%≤a≤+ 100%), and 31 separations (100%≤β≤400%) for 81 Froude numbers (0.20≤Fn≤ 1.0). In developing the three trimaran series, Wigley-st. AMECRC-09, and NPL-4a models were used separately for both the main and side hulls of each individu;d series models. A computer macro named Tri-PL was created using the Visual Basic for Applications~. Tri-PL~ sequentially interfaced Maxsurfe then Hullspeed to generate the models of the three trimaran series together with their detailed hydrostatic particulars, followed by their resistance components. The numerical results were partially validated against the available published numerical calculations and experimental results, to benchmark the Tri-PL macro and hence to rely on the analysis outcomes. A graph template was creaLed within the framework of SigmaPlot to visualize the significant results of the Tri-PL properlv. 展开更多
关键词 high speed trimaran (HST) hydrodynamic interference factor (HIF) trimaran hydrodynamicperformance separation of outriggers
在线阅读 下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部