期刊文献+
共找到4篇文章
< 1 >
每页显示 20 50 100
3—氯—2—羟丙基三甲铵氯化物的合成及其固色作用 被引量:8
1
作者 李同信 王雪梅 +1 位作者 李萌 丛铀 《精细化工》 EI CAS CSCD 1993年第2期19-21,共3页
考察了3—氯—2—羟丙基三甲铵氯化物的合成条件,改进了后处理方法。并考察了该化合物的固色效果。
关键词 固色剂 羟丙基 氯化
在线阅读 下载PDF
氯化肉碱腈的化学制备
2
作者 孙曰圣 张小林 杨期勇 《精细化工》 EI CAS CSCD 北大核心 2003年第7期409-411,421,共4页
研究了三甲胺盐酸盐与环氧氯丙烷在乙醇水溶液中催化反应生成氯化3 氯 2 羟丙基三甲铵(CHPTMA),再经氰化反应生成氯化3 氰 2 羟丙基三甲铵(氯化肉碱腈)的工艺。通过正交实验得到了催化反应最佳工艺条件:反应液pH=8~9、反应温度35℃、n... 研究了三甲胺盐酸盐与环氧氯丙烷在乙醇水溶液中催化反应生成氯化3 氯 2 羟丙基三甲铵(CHPTMA),再经氰化反应生成氯化3 氰 2 羟丙基三甲铵(氯化肉碱腈)的工艺。通过正交实验得到了催化反应最佳工艺条件:反应液pH=8~9、反应温度35℃、n(环氧氯丙烷)/n(三甲胺盐酸盐)=0 95、反应时间1h,在此实验条件下进行合成,产率93%。氰化反应最佳工艺条件:反应温度40~45℃、反应时间1 5h、n(氰化钠)/n(CHPTMA)=1 05,在此条件下,产率为78 8%。 展开更多
关键词 氯化肉碱腈 盐酸三 环氧氯丙烷 氰化 氯化3-氰-2-羟丙基三
在线阅读 下载PDF
铜的萃取动力学研究 被引量:5
3
作者 傅建顺 杨惠明 周展云 《高校化学工程学报》 EI CAS CSCD 1990年第3期255-262,共8页
本文用氯化三烷基甲铵(N_(263))—煤油体系作为有机相进行了从碱性氰化液中萃取铜的动力学研究。实验是在一恒界面池(Lewis cell)中进行的。实验结果表明:铜的萃取速率与两相的搅拌强度几乎无关;但正比于两相的接触界面积及萃取剂浓度;... 本文用氯化三烷基甲铵(N_(263))—煤油体系作为有机相进行了从碱性氰化液中萃取铜的动力学研究。实验是在一恒界面池(Lewis cell)中进行的。实验结果表明:铜的萃取速率与两相的搅拌强度几乎无关;但正比于两相的接触界面积及萃取剂浓度;萃取反应过程的表观活化能为18.750kJ/mol。对系统进行理论分析的结果可知,铜的萃取反应过程为反应与扩散在水膜内并列进行的过程,其主要特征表现为包含水膜的界面反应。通过数据处理,建立了如下萃取动力学模型:用此模型计算所得结果与实验结果的平均偏差为4.9%。 展开更多
关键词 萃取动力学 三烷基 氯化甲铵
在线阅读 下载PDF
FTIR analysis of adsorption of poly diallyl-dimethyl-ammonium chloride on kaolinite 被引量:4
4
作者 孙伟 刘文莉 胡岳华 《Journal of Central South University of Technology》 EI 2008年第3期373-377,共5页
The flocculation behavior of ultrafine kaolinite suspension was investigated through settlement tests and FTIR method was employed to probe the adsorption mechanism of flocculant on kaolinite. The results show that th... The flocculation behavior of ultrafine kaolinite suspension was investigated through settlement tests and FTIR method was employed to probe the adsorption mechanism of flocculant on kaolinite. The results show that the maximum settling rate of kaolinite occurs at pH value of 3.33,which is close to the point of zero charge(PZC) of kaolinite (3.5). This result is in good agreement with the double electric layer theory. Kaolinite suspension reaches the largest settling rate at a low concentration of 39 g/t for poly diallyl-dimethyl-ammonium chloride(PDADMA) flocculant,whereas for polyacrylamides(PAM) the dosage is required to be 500 g/t. When macromolecule polymer is adsorbed on surface,kaolinite particles may be flocculant due to the bridging effect. There are cation flocculant characteristic bands on the spectrum of kaolinite but no obvious shifting. Thus,the adsorption of poly diallyl-dimethyl-ammonium chloride on kaolinite surface is physical adsorption. 展开更多
关键词 ADSORPTION FTIR spectrum KAOLINITE poly diallyl-dimethyl-ammonium chloride ELECTROSTATIC FLOCCULANT
在线阅读 下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部