Compressional harmonic wave propagation from a cylindrical tunnel or borehole in an intact rock is the basis for investigation of the practical explosion waves in a fractured rock mass. The amplitudes of the radial st...Compressional harmonic wave propagation from a cylindrical tunnel or borehole in an intact rock is the basis for investigation of the practical explosion waves in a fractured rock mass. The amplitudes of the radial stress wave obtained from the universal distinct element code (UDEC) were compared with the analytical solutions for two cases with different conditions. Good agreements between the UDEC results and the analytical solutions have been achieved. It indicates that UDEC can model 2-D dynamic problems at a high degree of accuracy.展开更多
The importance of the pre-tensioned force of rock bolts has been recognized by more and more researchers. To investi- gate the effect of pre-tensioned rock bolts on stress redistribution around roadways, a numerical a...The importance of the pre-tensioned force of rock bolts has been recognized by more and more researchers. To investi- gate the effect of pre-tensioned rock bolts on stress redistribution around roadways, a numerical analysis was carried out using FLAC3D and a special post-process methodology, using surfer, is proposed to process the numerical simulation results. The results indicate that pre-tensioned rock bolts have a significant effect on stress redistribution around a roadway. In the roof, pre-tensioned rock bolts greatly increase vertical stress; as a result, the strength of the rock mass increased significantly which results in a greater capacity of bearing a large horizontal stress. The horizontal stress decreases in the upper section of the roof, indicating that pre-tensioned rock bolts significantly reduce the coefficient and the size of the region concentration of horizontal stress. At the lat- eral side, pre-tensioned rock bolts greatly increase the horizontal stress; therefore, the rock mass strength significantly increases which results also in a greater capacity of bearing a large vertical stress. The greater the size of pre-tensioned force, the larger the region of stress redistribution around a roadway is affected and the higher the size of the stress on the roadway surface the more the rock mass strength increases.展开更多
The spacing–burden(S/B) ratio plays significant role on rock fragmentation and proper utilization of explosive energy to minimize the undesirable damage.Low S/B ratio generates fine fragments due to pressure rings co...The spacing–burden(S/B) ratio plays significant role on rock fragmentation and proper utilization of explosive energy to minimize the undesirable damage.Low S/B ratio generates fine fragments due to pressure rings coalescence of two blast holes,whereas boulder generations were observed above optimum S/B ratio.Both conditions are not acceptable because of wastage of explosive energy.Therefore,to resolve this issue,a numerical model study was conducted to optimize the S/B ratio and to envisage its effect on rock fragmentation based on utilization of explosive energy.Finite element simulation tool was used to see the extent of two blast hole influence area variation with varying S/B ratio.The better results were obtained at S/B ratio of 1:2 with optimum utilization of peak explosive energy.The performance was observed based on peak kinetic energy,peak pressure,radial and hoop stresses on centre of the two blast holes,where pressure rings coalescence.展开更多
Using the Splitting Hopkinson Pressure Bar （SHPB） experimental system, investigations were made into the dynamic mechanical performances of underground soft rocks. The experiments proved that the measured stress-str...Using the Splitting Hopkinson Pressure Bar （SHPB） experimental system, investigations were made into the dynamic mechanical performances of underground soft rocks. The experiments proved that the measured stress-strain curves display the characteristics of plastic deformation. By making use of a revised overstress constitutive formula for the stress model and by taking into account that the strain rate and strain are a function of I - E（t）/Eo, a revised overstress constitutive formula for the stress model was simplified by applying dimensional analysis and consequently, a simplified overstress formula was obtained for the stress model. Then, by taking into consideration the effects of damage under a dynamic load on the dynamic loading strength of the rock, the continuous damage theory and the statistical strength theory were introduced into the development of the simplified overstress constitutive formula for the stress model. Hence, a damage-based constitutive formula for an overstress model, which can be appropriately applied to the analysis of full dynamic stress-strain curves, was developed. By using the simplified damage-based constitutive formula for an overstress model, the actually measured curves are fitted, indicating that the fitting curves and those actually measured are in good agreement.展开更多
Based on the analysis and research into ground pressure behavior law and surrounding rock deformation of a large number of roadways affected by mining activity,this paper proposed a relation between the surrounding ro...Based on the analysis and research into ground pressure behavior law and surrounding rock deformation of a large number of roadways affected by mining activity,this paper proposed a relation between the surrounding rock deformation during mining ,the surrounding rock deformation rate during stable stage of mining and the chain pillar width. Moreover,it established the relation between the total amount of surrounding rock deformation during service period of roadway and the chain pillar width,which provides a principal basis for choosing the chain pillar width.展开更多
Using an MTS816.03 test system and self-designed seepage apparatus, seepage tests of saturated broken rocks were conducted, and the influence of lithology, axial stress, grain size distribution and loading rate on see...Using an MTS816.03 test system and self-designed seepage apparatus, seepage tests of saturated broken rocks were conducted, and the influence of lithology, axial stress, grain size distribution and loading rate on seepage characteristics was analyzed. The results show that： （1） Under the same axial stress （12 MPa）, the permeability of different lithologic samples increases in the order： gangue 〈 mudstone 〈 sandstone 〈 limestone. The permeability of gangue is 3 magnitudes lower than that of limestone. The absolute value of the non-Darcy coefficient β increases in the order： limestone 〈 sandstone 〈 mudstone 〈 gangue. The non-Darcy coefficient β of limestone, which is positive, is 5 magnitudes lower than that of gangue. （2） With increasing axial stress, the permeability of saturated broken sandstone decreases, and the absolute value of the non-Darcy coefficient β increases. After the axial stress exceeds 12 MPa, the curves of permeability and non-Darcy coefficient β all tend to be stable. （3） With increasing Talbol power exponent, the permeability increases, and the absolute value of the non-Darcy coefficient β decreases. （4） With increasing loading, the permeability increases, and the absolute value of the non-Darcy coefficient β decreases. When the loading rate is 0.5 kN/s, the non-Darcy coefficient β is positive.展开更多
基金Projects 50278057 supported by National Natural Science Foundation of China and 2002CB412703 supported by 973 Project
文摘Compressional harmonic wave propagation from a cylindrical tunnel or borehole in an intact rock is the basis for investigation of the practical explosion waves in a fractured rock mass. The amplitudes of the radial stress wave obtained from the universal distinct element code (UDEC) were compared with the analytical solutions for two cases with different conditions. Good agreements between the UDEC results and the analytical solutions have been achieved. It indicates that UDEC can model 2-D dynamic problems at a high degree of accuracy.
基金Projects 2006BAB16B02 and 2006BAK03B06 supported by the National Scientific & Technological Foundation of China
文摘The importance of the pre-tensioned force of rock bolts has been recognized by more and more researchers. To investi- gate the effect of pre-tensioned rock bolts on stress redistribution around roadways, a numerical analysis was carried out using FLAC3D and a special post-process methodology, using surfer, is proposed to process the numerical simulation results. The results indicate that pre-tensioned rock bolts have a significant effect on stress redistribution around a roadway. In the roof, pre-tensioned rock bolts greatly increase vertical stress; as a result, the strength of the rock mass increased significantly which results in a greater capacity of bearing a large horizontal stress. The horizontal stress decreases in the upper section of the roof, indicating that pre-tensioned rock bolts significantly reduce the coefficient and the size of the region concentration of horizontal stress. At the lat- eral side, pre-tensioned rock bolts greatly increase the horizontal stress; therefore, the rock mass strength significantly increases which results also in a greater capacity of bearing a large vertical stress. The greater the size of pre-tensioned force, the larger the region of stress redistribution around a roadway is affected and the higher the size of the stress on the roadway surface the more the rock mass strength increases.
文摘The spacing–burden(S/B) ratio plays significant role on rock fragmentation and proper utilization of explosive energy to minimize the undesirable damage.Low S/B ratio generates fine fragments due to pressure rings coalescence of two blast holes,whereas boulder generations were observed above optimum S/B ratio.Both conditions are not acceptable because of wastage of explosive energy.Therefore,to resolve this issue,a numerical model study was conducted to optimize the S/B ratio and to envisage its effect on rock fragmentation based on utilization of explosive energy.Finite element simulation tool was used to see the extent of two blast hole influence area variation with varying S/B ratio.The better results were obtained at S/B ratio of 1:2 with optimum utilization of peak explosive energy.The performance was observed based on peak kinetic energy,peak pressure,radial and hoop stresses on centre of the two blast holes,where pressure rings coalescence.
基金supported by funds from the National Natural Science Foundation of China (Nos. 51374013, 51174005 and 51134012)the Huo Yingdong Funds for Young Teachers to Conduct Researches on Basic Sciences (No. 121050)+1 种基金the academic research activities subsidies for academic and technical leaders and backup candidate in Anhui provincethe funds for the Doctoral Program of Higher Education (No. 20133415110006)
文摘Using the Splitting Hopkinson Pressure Bar （SHPB） experimental system, investigations were made into the dynamic mechanical performances of underground soft rocks. The experiments proved that the measured stress-strain curves display the characteristics of plastic deformation. By making use of a revised overstress constitutive formula for the stress model and by taking into account that the strain rate and strain are a function of I - E（t）/Eo, a revised overstress constitutive formula for the stress model was simplified by applying dimensional analysis and consequently, a simplified overstress formula was obtained for the stress model. Then, by taking into consideration the effects of damage under a dynamic load on the dynamic loading strength of the rock, the continuous damage theory and the statistical strength theory were introduced into the development of the simplified overstress constitutive formula for the stress model. Hence, a damage-based constitutive formula for an overstress model, which can be appropriately applied to the analysis of full dynamic stress-strain curves, was developed. By using the simplified damage-based constitutive formula for an overstress model, the actually measured curves are fitted, indicating that the fitting curves and those actually measured are in good agreement.
文摘Based on the analysis and research into ground pressure behavior law and surrounding rock deformation of a large number of roadways affected by mining activity,this paper proposed a relation between the surrounding rock deformation during mining ,the surrounding rock deformation rate during stable stage of mining and the chain pillar width. Moreover,it established the relation between the total amount of surrounding rock deformation during service period of roadway and the chain pillar width,which provides a principal basis for choosing the chain pillar width.
基金provided by the National Basic Research Program of China (No.2013CB227900)the Ordinary University Graduate Student Research Innovation Project in Jiangsu Province for 2014 (No.KYLX_1370)the National Natural Science Foundation of China (Nos.11502229 and 51404266)
文摘Using an MTS816.03 test system and self-designed seepage apparatus, seepage tests of saturated broken rocks were conducted, and the influence of lithology, axial stress, grain size distribution and loading rate on seepage characteristics was analyzed. The results show that： （1） Under the same axial stress （12 MPa）, the permeability of different lithologic samples increases in the order： gangue 〈 mudstone 〈 sandstone 〈 limestone. The permeability of gangue is 3 magnitudes lower than that of limestone. The absolute value of the non-Darcy coefficient β increases in the order： limestone 〈 sandstone 〈 mudstone 〈 gangue. The non-Darcy coefficient β of limestone, which is positive, is 5 magnitudes lower than that of gangue. （2） With increasing axial stress, the permeability of saturated broken sandstone decreases, and the absolute value of the non-Darcy coefficient β increases. After the axial stress exceeds 12 MPa, the curves of permeability and non-Darcy coefficient β all tend to be stable. （3） With increasing Talbol power exponent, the permeability increases, and the absolute value of the non-Darcy coefficient β decreases. （4） With increasing loading, the permeability increases, and the absolute value of the non-Darcy coefficient β decreases. When the loading rate is 0.5 kN/s, the non-Darcy coefficient β is positive.
