期刊文献+
共找到4篇文章
< 1 >
每页显示 20 50 100
武汉地区典型土类动力非线性参数的统计分析 被引量:16
1
作者 孔宇阳 廉超 +1 位作者 李井冈 宋琛 《地震工程学报》 CSCD 北大核心 2014年第4期832-837,共6页
利用武汉地区地震安全性评价报告中共振柱实验获得的1 403组土动力非线性参数数据,统计出武汉地区7种不同土性不同埋深的土类在8个典型应变下的动剪切模量比和阻尼比的平均值。根据2个工程场地在实验值、统计平均值、规范值输入下的土... 利用武汉地区地震安全性评价报告中共振柱实验获得的1 403组土动力非线性参数数据,统计出武汉地区7种不同土性不同埋深的土类在8个典型应变下的动剪切模量比和阻尼比的平均值。根据2个工程场地在实验值、统计平均值、规范值输入下的土层地震反应分析结果,对比分析了3种土动力参数值对场地地震动参数的影响,对所给出的平均值的合理性进行分析。结果表明,与规范值相比,统计平均值与实验值的土层地震反应分析结果基本一致,计算结果真实合理,可供武汉地区场地土动力学参数实验数据缺乏时参考使用。 展开更多
关键词 武汉地区 共振柱实验 动力非线性参数 地震反应分析 合理性分析
在线阅读 下载PDF
渤海土类动力非线性参数及合理性 被引量:11
2
作者 兰景岩 刘红帅 吕悦军 《哈尔滨工程大学学报》 EI CAS CSCD 北大核心 2012年第9期1079-1085,共7页
针对当前我国土动力学特性理论研究大多集中在陆地,而海域典型土类的动力特征尚无系统性研究成果的问题,收集整理了渤海海域近40个海洋石油平台地震安全性评价报告中动三轴试验取得的372组土体动力非线性参数数据,给出了渤海海域不同土... 针对当前我国土动力学特性理论研究大多集中在陆地,而海域典型土类的动力特征尚无系统性研究成果的问题,收集整理了渤海海域近40个海洋石油平台地震安全性评价报告中动三轴试验取得的372组土体动力非线性参数数据,给出了渤海海域不同土类不同埋深的动剪切模量比和阻尼比的统计平均值.以典型场地为基础,对比分析了所给出的统计平均值与规范值、推荐值对场地地震动参数的影响,论证了所给出的平均值的合理性.研究结果表明,与规范值、推荐值对比,所给出的统计平均值与实测值的地震反应分析结果吻合程度高,合理可信,为渤海场地土动力学参数实测数据不足情况下的必要补充. 展开更多
关键词 渤海海域 动力非线性参数 统计平均值 合理性分析
在线阅读 下载PDF
结合ITD与非线性分析的通信辐射源个体识别方法 被引量:16
3
作者 任东方 张涛 韩洁 《信号处理》 CSCD 北大核心 2018年第3期331-339,共9页
信号细微特征提取是通信辐射源个体识别技术的关键。考虑到实测辐射源信号具有非线性、非平稳的特点,通过对信号时间序列复杂度的分析,提取一些非线性动力学参数作为指纹特征,进行辐射源个体识别。首先利用固有时间尺度分解(ITD)算法,... 信号细微特征提取是通信辐射源个体识别技术的关键。考虑到实测辐射源信号具有非线性、非平稳的特点,通过对信号时间序列复杂度的分析,提取一些非线性动力学参数作为指纹特征,进行辐射源个体识别。首先利用固有时间尺度分解(ITD)算法,对原始信号进行分解,利用相关系数选出若干合适的信号分量;之后提取每层信号分量的排列熵,近似熵以及样本熵组成特征向量,并通过实验优化相关参数的选择,最后采用支持向量机(SVM)对信号进行分类识别。利用实测舰船信号进行细微特征提取及分类实验,与一些细微特征提取方法对比,在信号种类增加时,本方法识别性能更优,证明了多尺度分析提取非线性参数的有效性。 展开更多
关键词 通信辐射源个体识别 固有时间尺度分解 细微特征提取 非线性动力参数
在线阅读 下载PDF
Nonlinear characteristics of induced spontaneous combustion process of sulfide ores 被引量:2
4
作者 潘伟 吴超 +2 位作者 李孜军 石英 杨月平 《Journal of Central South University》 SCIE EI CAS CSCD 2016年第12期3284-3292,共9页
To investigate the relationship between nonlinear parameters and spontaneous combustion tendency of sulfide ores, nine different sulfide ore samples were taken from a pyrite mine in China, and induced spontaneous comb... To investigate the relationship between nonlinear parameters and spontaneous combustion tendency of sulfide ores, nine different sulfide ore samples were taken from a pyrite mine in China, and induced spontaneous combustion experiment was carried out in the laboratory. Different stages of the induced spontaneous combustion process were studied by integrating wavelet technology and nonlinear dynamics theory. The results show that ignition points of all the ore samples are above 330 ℃, indicating that sulfide ores of the pyrite mine are difficult to combust spontaneously under normal mining conditions. Spontaneous combustion process includes three stages: incubation stage, development stage and approaching stage. The average temperature rising rate of the three stages are 1.0 ~C/min, 2.0 ~C/min and 4.2 ~C/min, respectively. During the spontaneous combustion process, mean values of approximate entropy and correlation dimension increase at first, and then decrease in the following stage. The mean value of the maximum Lyapunov exponent increases with the passage of reaction time. In a whole, correlation among the three nonlinear parameters firstly weakens, then enhances, and the best correlation period is at approaching stage. As ignition point increases, the maximum Lyapunov exponent of approaching stage decreases. Therefore, combustible tendency of sulfide ores could be qualitatively evaluated based on the maximum Lyapunov exponent of this stage. 展开更多
关键词 sulfide ores induced spontaneous combustion nonlinear parameters ignition point maximum Lyapunov exponent
在线阅读 下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部