A new methodology was proposed for contamination source identification using information provided by consumer complaints from a probabilistic view.Due to the high uncertainties of information derived from users,the ob...A new methodology was proposed for contamination source identification using information provided by consumer complaints from a probabilistic view.Due to the high uncertainties of information derived from users,the objective of the proposed methodology doesn't aim to capture a unique solution,but to minimize the number of possible contamination sources.In the proposed methodology,all the possible pollution nodes are identified through the CSA methodology firstly.And then based on the principle of total probability formula,the probability of each possible contamination node is obtained through a series of calculation.According to magnitude of the probability,the number of possible pollution nodes is minimized.The effectiveness and feasibility of the methodology is demonstrated through an application to a real case of ZJ City.Four scenarios were designed to investigate the influence of different uncertainties on the results in this case.The results show that pollutant concentration,injection duration,the number of consumer complaints nodes used for calculation and the prior probability with which consumers would complaint have no particular effect on the identification of contamination source.Three nodes were selected as the most possible pollution sources in water pipe network of ZJ City which includes more than 3 000 nodes.The results show the potential of the proposed method to identify contamination source through consumer complaints.展开更多
Sixteen priority polycyclic aromatic hydrocarbons(PAHs) in surface water samples were analyzed by gas chromatograph-mass spectrometer(GC-MS) to study their distribution and characterizing sources.The water samples wer...Sixteen priority polycyclic aromatic hydrocarbons(PAHs) in surface water samples were analyzed by gas chromatograph-mass spectrometer(GC-MS) to study their distribution and characterizing sources.The water samples were collected from five sites(J1-J5) in the Jialing River of Chongqing downtown area from September 2009 to August 2010.The results demonstrate that the concentration of total PAHs in three samples upstream are relatively higher than those in other two sites downstream,with average concentration of total PAHs for each site ranging from 811.5 ng/L to 1585.8 ng/L.The 2,3 and 4-ring PAHs for sampling stations account for 13.0%,56.6% and 28.6%,respectively,in total PAHs.There are obvious tendencies of seasonal change for PAHs concentration in surface water.The PAHs concentration in April of wet season is 1 301.6 ng/L,which is 1.3 times the lowest amount of total PAHs in August of flood season.Ratios of specific PAH compounds were used to characterize the possible pollution sources.Experimental results indicate that the PAHs in surface water samples are primarily from pyrolytic PAHs because of factories along these sites,while the direct leakage of petroleum products may be significant for two sites,Jiahua Bridge(J4) and Huanghuayuan Bridge(J5),because of the wharf boat nearby.展开更多
Water source heat pump is a new kind of energy saving process.One of the most common problems for water source heat pump system is the corrosion of the copper in heat exchanger.The quality of water is the key factor.T...Water source heat pump is a new kind of energy saving process.One of the most common problems for water source heat pump system is the corrosion of the copper in heat exchanger.The quality of water is the key factor.The river water collected in six different places of the Yangtze River and Jialing River in Chongqing were analyzed.Various parameters(pH,coexisted ions,and hardness value)were investigated.It showed that the Yangtze River and Jialing River water was suitable for developing water source heat pump technology.Further more,aimed at the temperature and pH of the raw water's variation range in a year,the corrosion behavior of copper material was studied by controlling the water environmental condition.Corrosion rate of copper is accelerated at high temperature and lower pH value.展开更多
It is complicated to model the acoustic field in stratified ocean for airborne aircraft,due to high speed of the source and air-to-water sound transmission.To our knowledge,there are very few papers in the open litera...It is complicated to model the acoustic field in stratified ocean for airborne aircraft,due to high speed of the source and air-to-water sound transmission.To our knowledge,there are very few papers in the open literature dealing with this complicated problem;but,in our opinion,they all require great amount of computation.We now propose a different method that requires much less computation.We improve the wavenumber integration method to model the received temporal signal for a moving source in stratified ocean and sum up in a concise form the core of our paper as follows:(A) Eq.(11) can be calculated by means of fast Chirp Z transform and the signals at all N time points are generated simultaneously;(B) direct numerical evaluation of the wavenumber integral in Eq.(4) produces large numerical errors;so it is necessary to shift the integration slightly below the real axis;(C) we compare the computation cost of direct calculation method with that of our fast calculation method;from the results presented in table 1,we can see that the fast calculation method consumes much less computation time,particularly for long duration signals;(D) for an airborne rapidly moving source,we compute the Doppler-shifted signals in shallow water and analyze their short-time Fourier transform;from Fig.1b,we can see that the received signals have multiple frequency components for a tonal source due to source motion and that each component corresponds to an arrival path.展开更多
This paper presents an approach to the challenging is- sue of passive source localization in shallow water using a mobile short horizontal linear array with length less than ten meters. The short array can be convenie...This paper presents an approach to the challenging is- sue of passive source localization in shallow water using a mobile short horizontal linear array with length less than ten meters. The short array can be conveniently placed on autonomous underwa- ter vehicles and deployed for adaptive spatial sampling. However, the use of such small aperture passive sonar systems makes it difficult to acquire sufficient spatial gain for localizing long-range sources. To meet the requirement, a localization approach that employs matched-field based techniques that enable the short ho- rizontal linear array is used to passively localize acoustic sources in shallow water. Furthermore, the broadband processing and inter-position processing provide robustness against ocean en- vironmental mismatch and enhance the stability of the estimation process. The proposed approach＇s ability to localize acoustic sources in shallow water at different signal-to-noise ratios is examined through the synthetic test cases where the sources are located at the endfire and some other bearing of the mobile short horizontal linear array. The presented results demonstrate that the positional parameters of the estimated source build up over time as the array moves at a low speed along a straight line at a constant depth.展开更多
基金Project(50908165) supported by the National Natural Science Foundation of China
文摘A new methodology was proposed for contamination source identification using information provided by consumer complaints from a probabilistic view.Due to the high uncertainties of information derived from users,the objective of the proposed methodology doesn't aim to capture a unique solution,but to minimize the number of possible contamination sources.In the proposed methodology,all the possible pollution nodes are identified through the CSA methodology firstly.And then based on the principle of total probability formula,the probability of each possible contamination node is obtained through a series of calculation.According to magnitude of the probability,the number of possible pollution nodes is minimized.The effectiveness and feasibility of the methodology is demonstrated through an application to a real case of ZJ City.Four scenarios were designed to investigate the influence of different uncertainties on the results in this case.The results show that pollutant concentration,injection duration,the number of consumer complaints nodes used for calculation and the prior probability with which consumers would complaint have no particular effect on the identification of contamination source.Three nodes were selected as the most possible pollution sources in water pipe network of ZJ City which includes more than 3 000 nodes.The results show the potential of the proposed method to identify contamination source through consumer complaints.
基金Project(41101457) supported by the National Natural Science Foundation of ChinaProject(2009-122) supported by the Fund of Chongqing Municipal Construction Commission, China
文摘Sixteen priority polycyclic aromatic hydrocarbons(PAHs) in surface water samples were analyzed by gas chromatograph-mass spectrometer(GC-MS) to study their distribution and characterizing sources.The water samples were collected from five sites(J1-J5) in the Jialing River of Chongqing downtown area from September 2009 to August 2010.The results demonstrate that the concentration of total PAHs in three samples upstream are relatively higher than those in other two sites downstream,with average concentration of total PAHs for each site ranging from 811.5 ng/L to 1585.8 ng/L.The 2,3 and 4-ring PAHs for sampling stations account for 13.0%,56.6% and 28.6%,respectively,in total PAHs.There are obvious tendencies of seasonal change for PAHs concentration in surface water.The PAHs concentration in April of wet season is 1 301.6 ng/L,which is 1.3 times the lowest amount of total PAHs in August of flood season.Ratios of specific PAH compounds were used to characterize the possible pollution sources.Experimental results indicate that the PAHs in surface water samples are primarily from pyrolytic PAHs because of factories along these sites,while the direct leakage of petroleum products may be significant for two sites,Jiahua Bridge(J4) and Huanghuayuan Bridge(J5),because of the wharf boat nearby.
基金supported by the China Postdoctoral Science Foundation(20080430747)foundation of Chongqing University Young Talents for Promoting the Innovative Force(qnjj2008-7)
文摘Water source heat pump is a new kind of energy saving process.One of the most common problems for water source heat pump system is the corrosion of the copper in heat exchanger.The quality of water is the key factor.The river water collected in six different places of the Yangtze River and Jialing River in Chongqing were analyzed.Various parameters(pH,coexisted ions,and hardness value)were investigated.It showed that the Yangtze River and Jialing River water was suitable for developing water source heat pump technology.Further more,aimed at the temperature and pH of the raw water's variation range in a year,the corrosion behavior of copper material was studied by controlling the water environmental condition.Corrosion rate of copper is accelerated at high temperature and lower pH value.
文摘It is complicated to model the acoustic field in stratified ocean for airborne aircraft,due to high speed of the source and air-to-water sound transmission.To our knowledge,there are very few papers in the open literature dealing with this complicated problem;but,in our opinion,they all require great amount of computation.We now propose a different method that requires much less computation.We improve the wavenumber integration method to model the received temporal signal for a moving source in stratified ocean and sum up in a concise form the core of our paper as follows:(A) Eq.(11) can be calculated by means of fast Chirp Z transform and the signals at all N time points are generated simultaneously;(B) direct numerical evaluation of the wavenumber integral in Eq.(4) produces large numerical errors;so it is necessary to shift the integration slightly below the real axis;(C) we compare the computation cost of direct calculation method with that of our fast calculation method;from the results presented in table 1,we can see that the fast calculation method consumes much less computation time,particularly for long duration signals;(D) for an airborne rapidly moving source,we compute the Doppler-shifted signals in shallow water and analyze their short-time Fourier transform;from Fig.1b,we can see that the received signals have multiple frequency components for a tonal source due to source motion and that each component corresponds to an arrival path.
基金supported by the State Scholarship Fund(2011611091)supported by China Shipbuilding Industry Corporation
文摘This paper presents an approach to the challenging is- sue of passive source localization in shallow water using a mobile short horizontal linear array with length less than ten meters. The short array can be conveniently placed on autonomous underwa- ter vehicles and deployed for adaptive spatial sampling. However, the use of such small aperture passive sonar systems makes it difficult to acquire sufficient spatial gain for localizing long-range sources. To meet the requirement, a localization approach that employs matched-field based techniques that enable the short ho- rizontal linear array is used to passively localize acoustic sources in shallow water. Furthermore, the broadband processing and inter-position processing provide robustness against ocean en- vironmental mismatch and enhance the stability of the estimation process. The proposed approach＇s ability to localize acoustic sources in shallow water at different signal-to-noise ratios is examined through the synthetic test cases where the sources are located at the endfire and some other bearing of the mobile short horizontal linear array. The presented results demonstrate that the positional parameters of the estimated source build up over time as the array moves at a low speed along a straight line at a constant depth.
