Aseries of [(Fe_(0.6)Co_(0.2)Ni_(0.2))_(0.75-0.03x)B_(0.2)Si_(0.05+0.03x)]_(96)Nb_(4) amorphous alloy composite coatings were prepared by adjusting the silicon content(x=0,1,2,3,4,5,and 6)and their microstructures and...Aseries of [(Fe_(0.6)Co_(0.2)Ni_(0.2))_(0.75-0.03x)B_(0.2)Si_(0.05+0.03x)]_(96)Nb_(4) amorphous alloy composite coatings were prepared by adjusting the silicon content(x=0,1,2,3,4,5,and 6)and their microstructures and tribological properties were investigated by laser cladding technique.Additionally,the effect of Si on the glass forming ability(GFA)of the layers was understood.Results show that an appropriate Si content can refine the microstructure of the FeCoNiBSiNb laser cladding layers and improve the mechanical and tribological properties.The hardness of the coating layer increases monotonically with the Si content.At the Si content of 4.8at%(x=0),the coating layer exhibits a relatively low hardness(734.2HV 0.1).Conversely,at the silicon content of 13.44at%(x=3),the coating layer exhibits the highest hardness(1106HV 0.1).The non-crystalline content and tensile strength exhibit an initial increase,followed by a subsequent decrease.At x=2,the coating exhibits its maximum fracture strength(2880 MPa).However,when x>2,the fracture strength of the coating decreases with an increase in x.Conversely,with an increase in Si content,the wear volume loss initially decreases and then increases.At a Si content of 10.56at%(x=2),the coating exhibits the highest non-crystalline content(42%),the highest tensile strength(2880 MPa),and the most favorable dry friction performance.展开更多
Limited research has been conducted on the influences of fiber content on close-in blasting characteristics for ultrahigh-performance fiber-reinforced concrete(UHPFRC)beams.This paper aims to address this knowledge ga...Limited research has been conducted on the influences of fiber content on close-in blasting characteristics for ultrahigh-performance fiber-reinforced concrete(UHPFRC)beams.This paper aims to address this knowledge gap through experimental and mesoscale numerical methods.Experiments were conducted on ten UHPFRC beams built with varying steel fiber volumetric fractions subjected to close-in explosive conditions.Additionally,this study considered other parameters,such as the longitudinal reinforcement type and ratio.In the case of UHPFRC beams featuring normal-strength longitudinal reinforcement of diametersΦ12,Φ16,andΦ20,a reduction in maximum displacement by magnitudes of19.6%,19.5%,and 17.4%was observed,respectively,as the volumetric fractions of fiber increased from1.0%to 2.5%.In addition,increasing the longitudinal reinforcement ratio and using high-strength steel longitudinal reinforcement both significantly reduced the deformation characteristics and increase the blasting resistances of UHPFRC beams.However,the effects on the local crushing and spalling damage were not significant.A mesoscale finite element model,which considers the impacts of fiber parameters on UHPFRC beam behaviors,was also established and well correlated with the test findings.Nevertheless,parametric analyses were further conducted to examine the impacts of the steel fiber content and length and the hybrid effects of various types of microfibers and steel fibers on the blasting performance of UHPFRC beams.展开更多
In order to study the effects of biochar-based organic fertilizer on the accumulation of the total flavonoid contents in dandelion after sowing,the experiment applied four levels of treatments of carbon-based organic ...In order to study the effects of biochar-based organic fertilizer on the accumulation of the total flavonoid contents in dandelion after sowing,the experiment applied four levels of treatments of carbon-based organic fertilizer(0.15,0.30,0.45,and 0.60 kg•m^(-2)),and the base fertilizer that only applied conventional chemical fertilizer was used as the control.The total flavonoid contents and physiological indices of dandelion in different growth periods were determined.The results showed that the accumulation of the total flavonoid contents in leaves and roots of dandelion improved significantly by applying biochar-based organic fertilizer(0.15,0.30,0.45,and 0.60 kg•m^(-2)),with the highest total flavonoid occurred in the 0.45 kg•m^(-2) biochar-based organic fertilizer treatment.Along with dandelion growing,the total flavonoid contents in leaves were first elevated,and then decreased,with the maximum reached at 95 days after sowing(anthesis).While the total flavonoid contents in roots were elevated constantly.The total flavonoid contents accumulation in dandelion were positively correlated with net photosynthetic rate,stomatal conductance,transpiration rate,soluble sugar content,soluble protein,nitrate nitrogen,and available potassium,while negatively correlated with intercellular CO_(2) concentration.展开更多
In challenging situations,such as low illumination,rain,and background clutter,the stability of the thermal infrared(TIR)spectrum can help red,green,blue(RGB)visible spectrum to improve tracking performance.However,th...In challenging situations,such as low illumination,rain,and background clutter,the stability of the thermal infrared(TIR)spectrum can help red,green,blue(RGB)visible spectrum to improve tracking performance.However,the high-level image information and the modality-specific features have not been sufficiently studied.The proposed correlation filter uses the fused saliency content map to improve filter training and extracts different features of modalities.The fused content map is intro-duced into the spatial regularization term of correlation filter to highlight the training samples in the content region.Furthermore,the fused content map can avoid the incompleteness of the con-tent region caused by challenging situations.Additionally,differ-ent features are extracted according to the modality characteris-tics and are fused by the designed response-level fusion stra-tegy.The alternating direction method of multipliers(ADMM)algorithm is used to solve the tracker training efficiently.Experi-ments on the large-scale benchmark datasets show the effec-tiveness of the proposed tracker compared to the state-of-the-art traditional trackers and the deep learning based trackers.展开更多
通过比较不同基质中药用石斛生长量和有效成份质量分数,探究经过无害化处理的松材线虫病疫木在铁皮石斛(Dendrobium officinale Kimura et Migo)人工栽培中作为配方基质的使用效果。结果表明:在铁皮石斛人工种植中使用经过无害化处理后...通过比较不同基质中药用石斛生长量和有效成份质量分数,探究经过无害化处理的松材线虫病疫木在铁皮石斛(Dendrobium officinale Kimura et Migo)人工栽培中作为配方基质的使用效果。结果表明:在铁皮石斛人工种植中使用经过无害化处理后的松材线虫病疫木作为栽培基质切实可行。不同栽培方式适用的松材线虫病疫木替代基质的比例不同。以盆栽方式种植铁皮石斛时,1号基质(V(粒径9~12 mm疫木颗粒)∶V(新鲜树皮)∶V(饼肥)=1∶1∶1)充分发酵后可以在实际生产中替代常规栽培基质使用;以盘栽方式种植铁皮石斛时,3号基质(V(疫木锯末)∶V(新鲜树皮)∶V(饼肥)=1∶1∶1)充分发酵后可以在实际生产中替代常规栽培基质使用。展开更多
文摘Aseries of [(Fe_(0.6)Co_(0.2)Ni_(0.2))_(0.75-0.03x)B_(0.2)Si_(0.05+0.03x)]_(96)Nb_(4) amorphous alloy composite coatings were prepared by adjusting the silicon content(x=0,1,2,3,4,5,and 6)and their microstructures and tribological properties were investigated by laser cladding technique.Additionally,the effect of Si on the glass forming ability(GFA)of the layers was understood.Results show that an appropriate Si content can refine the microstructure of the FeCoNiBSiNb laser cladding layers and improve the mechanical and tribological properties.The hardness of the coating layer increases monotonically with the Si content.At the Si content of 4.8at%(x=0),the coating layer exhibits a relatively low hardness(734.2HV 0.1).Conversely,at the silicon content of 13.44at%(x=3),the coating layer exhibits the highest hardness(1106HV 0.1).The non-crystalline content and tensile strength exhibit an initial increase,followed by a subsequent decrease.At x=2,the coating exhibits its maximum fracture strength(2880 MPa).However,when x>2,the fracture strength of the coating decreases with an increase in x.Conversely,with an increase in Si content,the wear volume loss initially decreases and then increases.At a Si content of 10.56at%(x=2),the coating exhibits the highest non-crystalline content(42%),the highest tensile strength(2880 MPa),and the most favorable dry friction performance.
基金supported by the National Natural Science Foundation of China(Grant No.12102050)the Open Fund of State Key Laboratory of Explosion Science and Technology(Grant No.SKLEST-ZZ-21-18)。
文摘Limited research has been conducted on the influences of fiber content on close-in blasting characteristics for ultrahigh-performance fiber-reinforced concrete(UHPFRC)beams.This paper aims to address this knowledge gap through experimental and mesoscale numerical methods.Experiments were conducted on ten UHPFRC beams built with varying steel fiber volumetric fractions subjected to close-in explosive conditions.Additionally,this study considered other parameters,such as the longitudinal reinforcement type and ratio.In the case of UHPFRC beams featuring normal-strength longitudinal reinforcement of diametersΦ12,Φ16,andΦ20,a reduction in maximum displacement by magnitudes of19.6%,19.5%,and 17.4%was observed,respectively,as the volumetric fractions of fiber increased from1.0%to 2.5%.In addition,increasing the longitudinal reinforcement ratio and using high-strength steel longitudinal reinforcement both significantly reduced the deformation characteristics and increase the blasting resistances of UHPFRC beams.However,the effects on the local crushing and spalling damage were not significant.A mesoscale finite element model,which considers the impacts of fiber parameters on UHPFRC beam behaviors,was also established and well correlated with the test findings.Nevertheless,parametric analyses were further conducted to examine the impacts of the steel fiber content and length and the hybrid effects of various types of microfibers and steel fibers on the blasting performance of UHPFRC beams.
基金Supported by the National Key Research and Development Project(2021YFD16009012021YFD1600902)。
文摘In order to study the effects of biochar-based organic fertilizer on the accumulation of the total flavonoid contents in dandelion after sowing,the experiment applied four levels of treatments of carbon-based organic fertilizer(0.15,0.30,0.45,and 0.60 kg•m^(-2)),and the base fertilizer that only applied conventional chemical fertilizer was used as the control.The total flavonoid contents and physiological indices of dandelion in different growth periods were determined.The results showed that the accumulation of the total flavonoid contents in leaves and roots of dandelion improved significantly by applying biochar-based organic fertilizer(0.15,0.30,0.45,and 0.60 kg•m^(-2)),with the highest total flavonoid occurred in the 0.45 kg•m^(-2) biochar-based organic fertilizer treatment.Along with dandelion growing,the total flavonoid contents in leaves were first elevated,and then decreased,with the maximum reached at 95 days after sowing(anthesis).While the total flavonoid contents in roots were elevated constantly.The total flavonoid contents accumulation in dandelion were positively correlated with net photosynthetic rate,stomatal conductance,transpiration rate,soluble sugar content,soluble protein,nitrate nitrogen,and available potassium,while negatively correlated with intercellular CO_(2) concentration.
基金supported by the National Natural Science Foundation of China(62073036,62076031)Beijing Natural Science Foundation(4242049).
文摘In challenging situations,such as low illumination,rain,and background clutter,the stability of the thermal infrared(TIR)spectrum can help red,green,blue(RGB)visible spectrum to improve tracking performance.However,the high-level image information and the modality-specific features have not been sufficiently studied.The proposed correlation filter uses the fused saliency content map to improve filter training and extracts different features of modalities.The fused content map is intro-duced into the spatial regularization term of correlation filter to highlight the training samples in the content region.Furthermore,the fused content map can avoid the incompleteness of the con-tent region caused by challenging situations.Additionally,differ-ent features are extracted according to the modality characteris-tics and are fused by the designed response-level fusion stra-tegy.The alternating direction method of multipliers(ADMM)algorithm is used to solve the tracker training efficiently.Experi-ments on the large-scale benchmark datasets show the effec-tiveness of the proposed tracker compared to the state-of-the-art traditional trackers and the deep learning based trackers.
