Hydrogenated microcrystalline and amorphous silicon thin films were prepared by very high frequency plasmaenhanced chemical vapour deposition （VHF PECVD） by using a mixture of silane and hydrogen as source gas. The ...Hydrogenated microcrystalline and amorphous silicon thin films were prepared by very high frequency plasmaenhanced chemical vapour deposition （VHF PECVD） by using a mixture of silane and hydrogen as source gas. The influence of deposition parameters on the transition region of hydrogenated silicon films growth was investigated by varying the silane concentration （SC）, plasma power （Pw）, working pressure （P）, and substrate temperature （Ts）. Results suggest that SC and Ts are the most critical factors that affect the film structure transition from microcrystalline to amorphous phase. A narrow region in the range of SC and Ts, in which the rapid phase transition takes place, was identified. It was found that at lower P or higher Pw, the transition region is shifted to larger SC. In addition, the dark conductivity and photoconductivity decrease with SC and show sharp changes in the transition region. It proposed that the transition process and the transition region are determined by the competition between the etching effect of atomic hydrogen and the growth of amorphous phase.展开更多
Highly conductive boron-doped hydrogenated mieroerystalline silicon （μc-Si：H） films are prepared by very high frequency plasma enhanced chemical vapour deposition （VHF PECVD） at the substrate temperatures （Ts）...Highly conductive boron-doped hydrogenated mieroerystalline silicon （μc-Si：H） films are prepared by very high frequency plasma enhanced chemical vapour deposition （VHF PECVD） at the substrate temperatures （Ts） ranging from 90℃ to 270℃. The effects of Ts on the growth and properties of the films are investigated. Results indicate that the growth rate, the electrical （dark conductivity, carrier concentration and Hall mobility） and structural （crystallinity and grain size） properties are all strongly dependent on Ts. As Ts increases, it is observed that 1） the growth rate initially increases and then arrives at a maximum value of 13.3 nm/min at Ts=210℃, 2） the crystalline volume fraction （Xc） and the grain size increase initially, then reach their maximum values at TS=140℃, and finally decrease, 3） the dark conductivity （σd）, carrier concentration and Hall mobility have a similar dependence on Ts and arrive at their maximum values at Ts-190℃. In addition, it is also observed that at a lower substrate temperature Ts, a higher dopant concentration is required in order to obtain a maximum σd.展开更多
Hydrogenated silicon （Si：H） thin films for application in solar ceils were deposited by using very high frequency plasma enhanced chemical vapour deposition （VHF PECVD） at a substrate temperature of about 170 ℃,...Hydrogenated silicon （Si：H） thin films for application in solar ceils were deposited by using very high frequency plasma enhanced chemical vapour deposition （VHF PECVD） at a substrate temperature of about 170 ℃, The electrical, structural, and optical properties of the films were investigated. The deposited films were then applied as i-layers for p-i-n single junction solar cells. The current-voltage （I - V） characteristics of the cells were measured before and after the light soaking. The results suggest that the films deposited near the transition region have an optimum properties for application in solar cells. The cell with an i-layer prepared near the transition region shows the best stable performance.展开更多
In this paper intrinsic microcrystalline silicon films have been prepared by very high frequency plasma enhanced chemical vapour deposition （VHF-PECVD） with different substrate temperature and pressure. The film pro...In this paper intrinsic microcrystalline silicon films have been prepared by very high frequency plasma enhanced chemical vapour deposition （VHF-PECVD） with different substrate temperature and pressure. The film properties were investigated by using Raman spectra, x-ray diffraction, scanning electron microscope （SEM）, and optical transmittance measurements, as well as dark conductivity. Raman results indicate that increase of substrate temperature improves the microcrystallinity of the film. The crystallinity is improved when the pressure increases from 50Pa to 80Pa and the structure transits from microcrystalline to amorphous silicon for pressure higher than 80Pa. SEM reveals the effect of substrate temperature and pressure on surface morphology.展开更多
文摘Hydrogenated microcrystalline and amorphous silicon thin films were prepared by very high frequency plasmaenhanced chemical vapour deposition （VHF PECVD） by using a mixture of silane and hydrogen as source gas. The influence of deposition parameters on the transition region of hydrogenated silicon films growth was investigated by varying the silane concentration （SC）, plasma power （Pw）, working pressure （P）, and substrate temperature （Ts）. Results suggest that SC and Ts are the most critical factors that affect the film structure transition from microcrystalline to amorphous phase. A narrow region in the range of SC and Ts, in which the rapid phase transition takes place, was identified. It was found that at lower P or higher Pw, the transition region is shifted to larger SC. In addition, the dark conductivity and photoconductivity decrease with SC and show sharp changes in the transition region. It proposed that the transition process and the transition region are determined by the competition between the etching effect of atomic hydrogen and the growth of amorphous phase.
文摘Highly conductive boron-doped hydrogenated mieroerystalline silicon （μc-Si：H） films are prepared by very high frequency plasma enhanced chemical vapour deposition （VHF PECVD） at the substrate temperatures （Ts） ranging from 90℃ to 270℃. The effects of Ts on the growth and properties of the films are investigated. Results indicate that the growth rate, the electrical （dark conductivity, carrier concentration and Hall mobility） and structural （crystallinity and grain size） properties are all strongly dependent on Ts. As Ts increases, it is observed that 1） the growth rate initially increases and then arrives at a maximum value of 13.3 nm/min at Ts=210℃, 2） the crystalline volume fraction （Xc） and the grain size increase initially, then reach their maximum values at TS=140℃, and finally decrease, 3） the dark conductivity （σd）, carrier concentration and Hall mobility have a similar dependence on Ts and arrive at their maximum values at Ts-190℃. In addition, it is also observed that at a lower substrate temperature Ts, a higher dopant concentration is required in order to obtain a maximum σd.
文摘Hydrogenated silicon （Si：H） thin films for application in solar ceils were deposited by using very high frequency plasma enhanced chemical vapour deposition （VHF PECVD） at a substrate temperature of about 170 ℃, The electrical, structural, and optical properties of the films were investigated. The deposited films were then applied as i-layers for p-i-n single junction solar cells. The current-voltage （I - V） characteristics of the cells were measured before and after the light soaking. The results suggest that the films deposited near the transition region have an optimum properties for application in solar cells. The cell with an i-layer prepared near the transition region shows the best stable performance.
文摘In this paper intrinsic microcrystalline silicon films have been prepared by very high frequency plasma enhanced chemical vapour deposition （VHF-PECVD） with different substrate temperature and pressure. The film properties were investigated by using Raman spectra, x-ray diffraction, scanning electron microscope （SEM）, and optical transmittance measurements, as well as dark conductivity. Raman results indicate that increase of substrate temperature improves the microcrystallinity of the film. The crystallinity is improved when the pressure increases from 50Pa to 80Pa and the structure transits from microcrystalline to amorphous silicon for pressure higher than 80Pa. SEM reveals the effect of substrate temperature and pressure on surface morphology.
